you just simply turn off your printer and unplug some of the cables connected to the printer and re plug them again.... turn off your computer so it wont get messed up...
hope it works :)
Or, go to printer icon and click on cancel printing.
Try printing something!
Attempt this technique and check whether it settle your concern. 1. Kill the printer and hold up ten seconds. Turn it on once more. 2. Give the printer a chance to print the test page. 3. After the test page is printed, separate the USB link that is associating the printer to your PC. Try not to not kill the printer while separating the link. 4. Place the test page on the scanner glass and press the SCAN catch on the printer control board. The On light will streak while the page is being checked. 5. Evacuate the test page when the On light is never again blazing. 6. Kill the printer and hold up an additional ten seconds. At that point you can Turn it on once more. Is it never again printing test pages? Presently you can reconnect the USB link between the PC and the printer.
If you're talking about setting up a printer on the computer then the use for that is to connect the printer to your computer so you are able to print. The computer will send "test" pages to print on your printer so you will know whether it works or not.
You probably need to install the correct printer driver. Go to the maker's website and search for the driver to suit your printer and your Operating System (which is not mentioned in your question).
This symptom is typical of a computer using an incorrect or damaged software driver. Initiate a test print directly from the printer while disconnected from PC. Usually by holding the power button down a few extra seconds as you turn it on. If the test page is good by this method I suggest you remove all printers listed in the windows control panel. Then download the most resent software drivers for your printer from the manufacture and install them as instructed by the manufacture before reconnecting the printer to the PC.
It depends on printer. For laser printers it's very easy to do, just print out test page using controls located on the printer itself. With other printer is harder because of absence of testing interface. The only choice you have is to connect the printer to computer try to get it printing. If does on one computer and does not do it somewhere else you point is proved.
It depends on printer. For laser printers it's very easy to do, just print out test page using controls located on the printer itself. With other printer is harder because of absence of testing interface. The only choice you have is to connect the printer to computer try to get it printing. If does on one computer and does not do it somewhere else you point is proved.
To fix your printer printing with a red tint, you can try the following steps: Check the ink levels in your printer and replace any low or empty cartridges. Clean the printhead to remove any clogs or dried ink that may be causing the red tint. Adjust the color settings on your printer to ensure they are properly calibrated. Print a test page to see if the issue has been resolved, and make further adjustments if necessary. If the problem persists, you may need to contact the manufacturer for further assistance or consider getting your printer serviced.
so it will work
The Test - Animorphs - has 135 pages.
First Test has 240 pages.
Test of the Twins has 330 pages.