0
Your right turn signal and brake light do not work and the front right turn signal blinks very very fast you have replaced both bulbs What could the problem be?
Wiki User
∙ 16y ago
Bad bulb socket?
Broken Wire to socket?
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Brake lights do not work all the time replaced brake light switch?
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
Why does only one brake come on on a 1990 cutlass and not the other just blinks third brake light out too checked fuses and bulbs?
My 1991 Olds Cutlass Ciera had that problem and it was corrected by replacing the turn signal switch. Troubleshooting with the factory service manual pinpointed the problem. Paul S
98 Monte Carlo that when the blinker is turned on only the brake light above the trunk works It only happens when the blinker is on other than that the brake lights work fine?
Problem most likely is in the Turn Signal switch. I had same problem , replaced Turn Signal switch assembly and that fixed it.
Cant get your brake lights to work on 1972 dodge dart?
i have a 72 nova and the left turn signal blinks faster than the right what is my problem
Brake lights keep blowing fuse when turn signal light is on 1987 ford bronco?
Replace turn signal switch. Its grounding when you put turn signals on. I had the same problem and replaced it .Solved issues.
Why does the third brake light work but not the other two brake lights I have a 1996 Ford Contour?
I am not sure on a ford but i had about the same problem on a GM car i had and it was the turn signal switch i replaced it and all the brake lights worked fine you might try that
Why does the signal lights of the bike goes on and off?
to differentiate it from a brake light or running lights. Its the only one that BLINKS at a regular rate when looking at it from the back.
What do you do if your brake lights only work when you pull back on your high beems in a buick reagal and how can it be fixed andor what is making this happen?
I have the same problem- press on the brake, no brake lights. Press on the brake and pull back on turn signal/high beams lever, brake lights turn on! Jiggle the lever, brake lights turn on, but left turn signal does not work. I have replaced the switch that is down near the brake pedal and that is not the problem. I think you may need to replace the whole turn signal/high beams/cruise control switch....or at least that's what I'm going to try.
Your 1998 Toyota Camry the right side blinker blinks rapidly when your head-lights are turned on it blinks at normal speed when lights are off what is causing this to do so?
change the bulb out for the brake light and that fixes the problem.
What does it mean when the rear brake light does not work and the turn signal flashes fast?
Usually when ones turn signal is blinking fast its telling you that a turn signal bulb (and in some cases a brake light bulb) is out. If it blinks fast when you turn on the the left signal the burnt out bulb is on that side of the vehicle (could be front or rear bulb so you'll have to check). And vice versa
Fix this problem with your carlast night you were driving home from work and the police pulled you over cuz your all the brake light not orking the three of themi replaced all of them and you checked?
usually faulty brake lights are either the brake light switch that senses when you press on the brake pedal, a connector somewhere between the brake light switch and the brake lights or the turn signal switch.
1997 lumina you have no brake lights but your back dash light works?
It's the turn signal switch at the steering wheel, that is the problem. Very exspensive to get replaced,and to hard for an amuture to do. If you have checked all fuses and bulbs sounds like ur turn signal switch in ur steering wheel. I had the same problem and was switch.
