answersLogoWhite

0


Best Answer

The starter drive, also sometimes called the bendix, needs to be replaced.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your snow blower will not start you press the start button and there is a whirling noise onlythe engine do not engage?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does the AC clutch engage when the blower switch is turn on and AC button is off 2003 RAM 1500 pick up?

You most likely have a bad a/c - heater controller........


Why won't your deck engage on mower?

transmission won't engage when you push the button on john deer 155c automatic


My 1994 Honda Accord's blower comes on only after hitting a bump Is it the relay or needs replacement?

Blower is about to die. I had same symptoms. Blower would not come on so I would run over bumps then it would engage. Replace blower no problems since.


Why won't the compressor engage on a 2001 4Runner when the AC button is pressed?

Here is advice: * Blown fuse or possibly the blower must also be turned on. * i would check the fuse for a/c . failing this i would test the switchin car , then check wiring at compressor


Why does fan blower not work and compressor clutch will not engage fuses look good?

i think these is not a proper question i do not know


How do you engage 4x4 on 2003 Honda Pilot?

To engage the 4x4 manually (VTM-4), you would need to be in 1st, 2nd, or reverse gear. In those gears and while stopped, you can then press the VTM-4 button, and will engage 4x4. It will only be engaged when around 18mph or lower. Above that, and it will disengage. It will re-engage when it dips down to that speed again. To turn it off, you can just press the button, or shift to a higher gear Keep in mind that even with the button off, VTM-4 will engage occasionally when there's slippage.


When you turn the blower motor select nob to the left it does not engage the AC system?

Check the refrigerant pressure. There is a sensor that detects the pressure of the refrigerant. If the pressure is not high enough the compressor will never engage.


What can you do if the gear shift button will not engage and the gear shift is stuck . 2001 impala does not blower motor does not work on the 1 setting?

There's a safety interlock controlled by ign. key on and brake pedal depressed; you should hear the solenoid click near the gearshift. If not, you'll need to trace loss of power. Start w/ fuses. Blower motor speed control for all speeds other than high, are controlled by a blower resistor, usually located in the ductwork near the blower. They will eventually burn out, requiring replacement. See item #4.


Why does the 4 wheel drive not engage when you push the button?

Regita love Marie-Claire


How do you engage 4 wheel drive in 2006 Suzuki xl7?

Press the 4WD button.


What would cause the transfer case on a 1996 sliverado not engage?

do you engage 4WD manually or via the button on the dash? if its the latter then your actuator switch is probably bad. tweek


1997 jimmy electronic 4 wheel drive will not engage when pushing the botton. What are the possibilities?

check and make sure it contacts, theres not much room behind that button and any play may cause it not to connect, push the dash assembly around the button firmly with one hand and push the button with the other, does it light up and engage