Take it to a mechanic. If you strip them, you are going to have to have everything rethreaded which is more than the cost you are saving by doing your own tune-up.
Cut them off- after 10 years it's time to replace
Pull on the boot.
to change the spark plugs first take off the plastic cover on top of the motor, the spark plugs are on the center of motor you see two coils on top of the two center spark plugs and two spark plugs wires going to the out side spark plugs you pull the wires off and you need a long socket wrench or a spark plug socket with extension bar to take it off, also you need to pull the coils to replace the center spark plugs they are under the coils. NOTE. this is for a four cylinder engine. excuse my English B. Cerda.
The spark plugs are on the front and back of a V6 (back ones are tough to get to) L4 right in front. Turn the engine off and take off the spark wires unscrew the plugs
i have a metal sleeve over each spark plug wire at the motor.....cant get the wire out to get to the plugs?? how do i get the wire off the plug??
How to replace spark plugs on a 2010 ford fusion
to change the spark plugs first take off the plastic cover on top of the motor, the spark plugs are on the center of motor you see two coils on top of the two center spark plugs and two spark plugs wires going to the out side spark plugs you pull the wires off and you need a long socket wrench or a spark plug socket with extension bar to take it off, also you need to pull the coils to replace the center spark plugs they are under the coils. NOTE. this is for a four cylinder engine. excuse my English B. Cerda.
Pull the spark plug wires off the spark plugs. Remove the spark plugs with a spark plug socket. Install the new spark plugs and put the spark plug wires back on. I recomend replacing the spark plug wires as well. If replacing them, just remember that the new wires are hooked up the same ways that the old ones came off.
you must take the top module off the engine and then remove the rubber plugs that are on top of the spark plug, then use the spark plug sockets to get them out you must take the top module off the engine and then remove the rubber plugs that are on top of the spark plug, then use the spark plug sockets to get them out you must take the top module off the engine and then remove the rubber plugs that are on top of the spark plug, then use the spark plug sockets to get them out
You may bolts on left side cover to access spark plug.The plugs are located on the bottom sides of the engine.
Just follow the ign. wires to the plugs, and use a spark plug socket.
on the 3.5 v6 take off the engine cover, unscrew the coilpacks and take out the spark plugs.