yes you can it will come out through the top
Yes you need to remove the subframe to remove the gearbox on elantra. the motor must be supported at the top before u remove the subframe.
Remove both wheels, Disconect both tie rods from from steering knuckle, remove the stabilizer bar, unplug O2 sensor, diconnect the catalitic converter from exhaust manifold ( unscrew the catalitic converter and lower the whole assembly as one) this will gave you more room when sliding the rack and pinion out of the subframe), unplug and plug both power steering lines connected to the steering gear, remove the two bolts holding the rack and pinion to the subframe.
Remove the power steering pump bracket. It can be done without dropping the rack.
Drop the complete engine and subframe. it pays 16 hours.
Remove the plug on the bottom of the power steering fluid pump. Drain the power steering fluid out. Replace the plug to the bottom of the power steering pump. Replace the power steering fluid.
Hi, first you don't say which bushes you need to change/ replace?The two large location bushes at the back of the top side of the front subframe on all models of Megane from 2003 onwards are notorious for failing with age. These bushes are not available from Renault without purchasing the full subframe, however a company called Commonsense Car Parts in Dundalk, Co Louth, Ireland do supply them. The steering rack needs to be disconnected first, thenthe two large bolts that travel upwards through these bushes must be undone, as well as the two bolts to the front of the subframe. This will allow the subframe to drop allowing access to the two bushes. Simply tap them out from the bottom and tap the new ones in.
It's possible a seal has broken. Find where it leaks from, could be pump, hose or steering ram. Then replace part.
How to replace power steering pump on Audi
Support the engine and transaxle from above using a support bar. Raise the vehicle on a hoist lift. Remove the front lower control arms and swaybar bushings from the subframe. Support the subframe with tall jackstands. Unbolt the engine and trans mounts from the subframe. Remove and clips or brackets for such things as oil coolers or wiring attached to the subframe. Remove the susbframe mounting bolts, then lower the subframe from the car. Reverse the procedure. Get a wheel alignment. Be sure to tell whoever is doing it that you replaced the subframe as this information is critical for the alignment to come out the way it should.
What have to do replace the belts water pump power steering
A person removes the airbag, and then the steering wheel with a steering wheel puller. Then pull out the sensor and clock spring, replace both, and replace the steering wheel and the airbag.Ê
One can replace a steering wheel by taking the top cap off, remove the screws, pull the steering off and then one can place the new steering wheels into the steering bracket.