Want this question answered?
no. input impedance is low & output impedance is high
main volage
To get all the audio voltage from a source to a target without loss you need voltage bridging, that is a relative low output impedance to a higher input impedance. Usualy the input impedance is at least ten times higher then the output impedance.An input impedance is called also a load impedance or an external impedance.An output impedance is called also a source impedance or an internal impedance.
The input impedance of a current shunt feedback amplifier is the open loop impedance of the amplifier divided by 1+(A*beta)
In audio the input impedance of an amplifier is between 10 kiloohms and 20 kiloohms.
Output of the power amplifier is smaller 0.1 ohms and input of the loudspeaker is more than 4 ohms.
That depends on the output impedance. In electronic we use voltage bridging, that is a relative low output impedance to a higher input impedance. Usualy the input impedance is more than ten times higher then the output impedance. An input impedance is called also a load impedance or an external impedance. An output impedance is called also a source impedance or an internal impedance.
To increase the power gain ,high input impedance,low output impedance,and increase the weaken signal
Connecting a resistance btw the o/p and i/p of the amplifier to increase the i/p impedance is called bootstrapping..
A common base NPN amplifier is used for high frequency applications as the base minimize oscillations at high frequency, separates the input and output. In a common base NPN amplifier the voltage gain is high, relatively low input impedance and high output impedance compared to the common collector.
makes it bigger! (or sometimes smaller, or sometimes the same, but with lower output impedance)
For the successful amplification of the input signal the opamp should have ideally infinite input impedance . It should act like a buffer amplifierBUFFER amplifier--------------------->1.input impedance infinity2.output impedance zerothe reason is thatAny signal source will have source impedancefor the signal not to get lost and dropped across source impedance we ideally insert infinite impedance in series with it which makes the whole drop across the infinite impedance but not across the sourcesimilarly at the output zero impedance is used where in no part of the signal should be left behind in the op amp as a drop