The average cost is about $700 for the labor only.
its one of the solenoid on the vavle bondy inside the transmission
Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced. Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced.
yes you can ,but you will need to buy and have installed, a new flywheel, bell housing, transmission, clutch, and drive shaft. then you will also have to have installed a clutch pedal inside the car. and to top it off, it the car has a computer, you will need to buy a computer to match a standard shift instead of an automatic shift. cheaper just to change cars
I need an answer to this too.
get a mecanic to do the job
A Concorde has an automatic transmission. It does not have a clutch.A Concorde has an automatic transmission. It does not have a clutch.
Torque Converter Clutch
I'm not very familiar with this vehicle, but two things come to mind immediately: 1) the clutch disk was contaminated with grease or oil during the transmission installation or 2) it's not adjusted properly. If the transmission was installed by a professional, I would suggest returning the vehicle to him to have it fixed. It may be covered under his warranty on the installation.
To install a new clutch in a Geo Tracker, first the negative battery cable must be disconnected and the vehicle lifted on jack stands. After removing the driveshaft and all wiring connections from the transmission, the transmission should be removed. From there, a new clutch disk may be installed.
Honda Accord clutch replacement prices depends on several condition such as the location, type of clutch being installed, and mechanic doing the work. On average the clutch replacement take between 4 and 5 hours. The average cost of mechanical labor in 2014 is between $50 and $100.
You have a hydraulic clutch, most if not all of this type do not have an adjustment. Most likely suspect is the slave cylindar on the transmission. That or the master cylindar, but the slave is more likely. Put a repair kit in or replace slave cylindar. Neither is very costly.
Transmission fluid will do work for your clutch my friend no worries here.