0
1978 ford Engine frozen - can you break it loose by pulling w an automatic transmission?
it is pretty hard to turn over an engine by towing if it is auto transmission you can try to break it loose, using right size soket and long breaker bar on the big bolt in the centre of the harmonic balancer on front of engine you dont say if this sngine is gas or diesel if it is gas, usually only way it will be locked,(frozen) is if the bearings are shot or something in engine is broken and locking it up if diesel engine, it can get a compression lock. this will usually free itself if just left alone, or using aforementioned method, turn engine over in the opposite direction of a running engine usually if a diesel is locked up by compression lock, it is caused by coolant getting into combustion chamber if this is the problem, check for a bad head gasket
What else can I help you with?
Why would your 1990 dodge truck 360 auto shift hard or hold to a high rpm?
Dodge Automatic Shifts HardThe downshift linkage that connects the throttle body to the transmission is either frozen or out of adjustment. Frozen linkage is common problem for Dodge automatics.
Can you push a yardman riding mower It has neutral but it does not roll?
if this is a gear transmission, it should roll in neutral unless the transmission is damaged or the brake is frozen, hydrostatic transmissions have a release mechanism for moving them when engine is off.
Why is your Lincoln Mark 8 pulling to the left when you brake?
Could be a partly frozen caliber.
How many transmission bolts on the bell housing on a 1993 GMC 1500 2 wheel drive?
It has 6 bolts holding it to the engine. It has 3 maybe 4 torque converter bolts that need to be removed too. There are 2 line-up pins in the back of the block that go into the transmission. If you can't get the trans loose from the engine then I would say those pins are frozen in the transmission bell housing. You will just need to PRY the transmission loose from the engine. It is stuck on the pins.
How do you separate a frozen engine 96 Olds 3.1L from its transmission I have removed 2 of 4 converter bolts...Do I have to remove the eng trans as one unit Any help is greatly appreciated.?
UPDATE: I removed the engine with the torque converter. It was messy, and when I got the engine out I was able to unbolt the converter.
Why has your engine frozen?
it hasn't?what does yous means?
What would cause a driveshaft to bind in a th350 after changing u-joint?
If all the u joints were replaced it could be a broken or frozen wheel bearing. A broken gear in the transmission, a broken bearing in the engine.
What did people say when Walter gearloose tried to drag his sheep across a frozen pond?
Walt is pulling the wool over our ice!
Can frozen engine be fixed?
Not without a significant monetary infusion...
How do you unfreeze a frozen engine?
If you mean frozen as in seized, the engine will need to be rebuilt, as parts have welded themselves together and there is most likely some serious damage to the pistons and cylinder bores.
94 dodge spirit sitting for 3 years what do you expect to deal with?
Dead Battery? Bad gasoline Frozen engine rings? Belts/hoses/ tires dry rotted? Transmission seal Power steering seal Brake lines dry rotted (front) Brake lines rear rusted? Brakes frozen?
How do you unlock hood when frozen?
Pulling the latch cable inside the car, then going around the hood and pounding on it with your fist will normally unlock the hood, unless your cable is frozen. If the cable is frozen, its probly best to wait for warm weather, or to borrow someones garage for a day, and let it defrost itself.
