answersLogoWhite

0

If a 1989 Buick Reatta cranks but has no spark, potential issues could include a faulty ignition coil, a malfunctioning ignition control module, or a problem with the crankshaft position sensor. Additionally, checking the wiring and connectors for any shorts or corrosion is essential. It's also worth examining the power supply to the ignition system and ensuring that the fuel pump is functioning properly, as these systems often interact. A diagnostic scan could help identify any error codes related to the ignition system.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

2003 dodge stratus cranks but no start what the problem?

i hit he curb and put a hole in the oil pan ,i replace the oil pan now the engine cranks but doent start. what could be the problem


What could be the problem with starting your 2001 Honda civic when it cranks and turns over but won't start?

could be disdributor


1987 Ford Ranger cranks but does not fire what could be the problem?

check map sensor that was the problem in my 89 2.3 ranger


Why does the 3000gt cranks good but does not start only cranks?

The problem is in spark, or fuel. Rarely the Crank angle sensor. ECU could be going bad too.


Your car cranks sometimes starts sometines doesnt could this be a transmission problem?

THE netural Saftey Switch could B bad .


What could be wrong with a 1989 Lincoln Continental V6 3.8 if it cranks but does not start?

I can't say for certain but I think that year has a crank sensor which could be bad also it could be a fuel problem or even an ignition problem


Your 96 achieva engine cranks but will not fire whats the problem?

There are several reasons why a 1996 Achieva engine cranks but will not fire. A few of the reasons could be a bad ignition control module, ignition coil pack, or a crankshaft position sensor.


What if the electronic speedometer on your 1992 buick regal does not work what could be the problem?

Vehicle Speed Sensor


What would cause Buick Skylark not to start with a new starter?

You need to be more specific about your problem. If it fails to crank, it could be it is not installed properly. Shims may be needed to make sure it engages the fly wheel gears properly.If it cranks, but does not start, then there are many electrical problems that could cause this. This begs the question, did it run OK before replacing the starter?


What could be the problem if your 92 Chevy Corsica is driving fine and then it starts to sputter and stall it cranks back up and stalls when put in gear?

TCC Solenoid.


If my 94 Acura Integra cranks but wont start What could be the problem?

check the fuel lines.. fuel relay, fuses, and if all else fails the pump.


What could be the problem on a 1999 buick century when it takes 15 minutes to warm up?

Thermostat is stuck open.