That's common; you need to put a "splitshot" between the cable and the small bolt on the right side cable so it "shortens" the cable about 1/8 inch.....The cable gets a "little" slack and it alway sefects the right side...
No,the driver-side airbag premiered on the 1990 Corvette as standard.Also the passenger-side airbag premiered on the 1994 Corvette as standard too.
1990 A new Corvette ZR-1 model debuts and a driver-side airbag becomes a standard feature.
American Dreamer - 1990 Corvette Man 1-5 was released on: USA: 13 October 1990
To open the back hatch on a 1990 Corvette, first ensure the vehicle is unlocked. Locate the hatch release button on the driver's side door panel or use the key fob if equipped. If the electronic release isn't functioning, you can manually unlock it by inserting the key into the lock located on the hatch itself. Once unlocked, lift the hatch upwards to access the trunk area.
To release the emergency brake on a 1990 Corvette, locate the emergency brake lever between the driver's seat and the center console. Pull the lever up slightly to disengage the locking mechanism, then push the release button on the end of the lever while lowering it back down to its original position. Ensure the vehicle is in gear or park before attempting to release the brake. If the brake is stuck, check for any obstructions or consult a professional for assistance.
the 1990 corvette had the LT-1 motor 300bhp and 340fpt that is the correct answer to this question!
Depends on the year. ALL newer Corvettes have air bags. Driver side only beginning in 1990, driver and passenger air bags first used 1994
The VATS (Vehicle Anti-Theft System) module on a 1990 Corvette is located under the dashboard, specifically on the driver's side. It is typically mounted on or near the steering column. To access it, you may need to remove the lower dash trim panel.
Our 1990 Corvette convertible weighs 3301 pounds.
== == No,the driver airbag arrived in 1990 as standard and the passenger airbag in 1994 as standard too.
The relay for the engine cooling fan on a 1990 Corvette is located in the engine compartment, specifically in the relay center near the driver’s side of the engine bay. It is typically mounted on the driver's side fender well. You can identify it by referring to the under-hood relay diagram, which provides the exact location and identification for the cooling fan relay.
== ==