0
What else can I help you with?
Info need'd on wiring starter of 454 big block Chevy?
The positive battery cable goes on the big terminal, in the center. Ignition wire, from the fuse box, ultimately the key, goes to the inside terminal on the selenoid. Then, I wlould run a wire from the outside small terminal, to the coil. This will give the motor 12 volts, while cranking.
How do you wire a citroen saxo ignition barrel?
To wire an ignition barrel in the Citroen Saxo, begin by disconnecting the wire at the negative terminal of the battery. A lead wire has to go to the ACC terminal on the ignition barrel. The starter relay wire goes to the ST terminal and the ignition wire is connected to the IGN terminal.
Why 1996 camaro won't start has no power to starter ignition switch is good?
1. bad starter selenoid 2. blown fuse in the circuit 3. bad ground at the starter (not likely, but possible) Start at the starter, with a test light, and work your way back through the curcuit until you find power. That's where the problem will be. If the starter has no power move to the selenoid. If the selenoid had no power in the switch circuit move to the fuse. If the selenoid has no power on the battery side move to the fusable link. Keep working your way to the ignition switch.
Why would the earth terminal get hot when the car is off?
This depends what Earth Terminal you mean The one on the top of the battery, You may have a bad battery. Disconect it and come back in 24 hours and see if it is dead. Not dead means that there is a short in the electrical system and this terminal needs cleaning. If the battery is dead the battery is bad, replace it. If this is another terminal and gets hot and stays hot it means there is a large draw on the system and this terminal is dirty and requires cleaning. The hot terminal is allways the highest resistance in the system. Good Luck
Honda crx alternator wiring?
To wire the alternator on a Honda CRX, start by identifying the main components: the battery terminal, the ignition or "S" terminal, and the field or "L" terminal. Connect the battery terminal to the positive battery cable, ensuring a secure connection. The "S" terminal connects to the ignition switch, while the "L" terminal connects to the dashboard indicator light. Always refer to a service manual for your specific model year for detailed wiring diagrams and safety precautions.
How do you wire a prestolite distributor?
To wire a Prestolite distributor, first ensure the ignition is off and the battery is disconnected. Connect the primary ignition wire from the ignition coil to the terminal marked "B" on the distributor. Then, connect the secondary wire from the distributor cap to the ignition coil's output terminal. Finally, ensure that all connections are secure and that the distributor is properly grounded before reconnecting the battery and testing the ignition system.
We cleaned the battery terminal and now the car will not idle properly?
Cleaning the battery terminals had nothing to do with the engine not idling properly. Just a coincidence.
Put battery charger on sears mower and engine starts to turn over as soon as the charger is pluged in?
Sounds like the starter relay or solenoid is stuck. Check the selenoid - the selenoid might be stuck closed which would cause the starter to turn because the power wouldn't be shut off from the battery. Or it may be the ignition switch is stuck in the start position.
How do you wire ignition for 66 dodge coronet?
To wire the ignition for a 1966 Dodge Coronet, first ensure you have the correct wiring harness and ignition switch. Connect the battery positive terminal to the ignition switch, and then run a wire from the ignition switch to the ignition coil's positive terminal. The negative terminal of the coil should be connected to the distributor. Lastly, make sure the starter solenoid is properly wired to ensure the engine can crank when the ignition is turned on.
How do you wire up ignition switch for 1986 cj5 diagram please?
To wire up the ignition switch for a 1986 Jeep CJ5, first identify the switch terminals: typically, you'll find terminals for battery (B), ignition (I), accessory (A), and starter (S). Connect the battery wire to the B terminal, the ignition wire to the I terminal, the accessory wire to the A terminal, and the starter wire to the S terminal. Ensure all connections are secure and insulated to prevent short circuits. Consult a wiring diagram specific to your model for clarity and to confirm wire colors.
Replace battery 2004 Dodge Durango?
REMOVAL Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off. Loosen the battery negative cable terminal clamp pinch-bolt hex nut. Disconnect the battery negative cable terminal clamp from the battery negative terminal post. If necessary, use a battery terminal puller (2) to remove the terminal clamp from the battery post. Loosen the battery positive cable terminal clamp pinch-bolt hex nut. Disconnect the battery positive cable terminal clamp from the battery positive terminal post. If necessary, use a battery terminal puller (2) to remove the terminal clamp from the battery post. Remove the battery cables from the battery. Remove the battery thermal guard (1). Remove the battery hold down bolt (1) and battery hold down (2) from the battery. WARNING: Wear a suitable pair of rubber gloves (not the household type) when removing a battery by hand. Safety glasses should also be worn. If the battery is cracked or leaking, the electrolyte can burn the skin and eyes. Remove the battery from the battery tray.
How do you hook up a 6 volt positive ground ignition coil on a 1949 ford tractor?
To hook up a 6-volt positive ground ignition coil on a 1949 Ford tractor, first ensure the tractor's battery is disconnected. Connect the positive terminal of the coil to the ignition switch, and the negative terminal to the distributor. Make sure the battery's positive terminal is connected to the chassis ground, as the system operates on positive ground. Finally, reconnect the battery and check for proper spark when cranking the engine.
