Double check the battery cables at the battery and at the engine, be sure they are clean and tight.
The starter solenoid is mounted directly to the starter.
The starter solenoid on a Honda Element is integral to the starter. It cannot be replaced without replacing the starter as well.
The starter solenoid is located on top of the starter. It is the small cylinder attached to the starter. It is a part of the starter which can be replaced/repaired independent from the starter itself.
If it is a v6 motor left side of trans on starter if it clicks when trying to start sometimes you can peck on starter motor to get started but will stop working again will need replaced
I DO BELIEVE THE SOLENOID IS MOUNTED ON THE STARTER AND YOU WOULD HAVE TO REPLACE THE STARTER TO REPLACE THE SOLENOID remove the starter and take it down to your local auto parts store. they can bench test the starter and give you the proper solenoid if it needs to be replaced.
The starter solenoid shows to be on top of starter. If you don't know where the starter is located, follow the positive battery cable. You may have to get under vehicle to get at the starter. I replace starter and solenoid as a unit. Now, if your talking about starter relay that is a different animal.
The starter solenoid can be replaced by removing the wiring harness. Remove the retaining nuts. The solenoid will come off. Reverse the process to install the new solenoid.
may be on top of the starter and replaced with same. Follow the + battery cable it will connect to the solenoid
You should locate and test the solenoid. Most have three connections. There is a large cable from the battery to the solenoid, from the solenoid to the starter and from the start switch to the solenoid. The power terminals to the battery and the starter are large and have large cables. The starter switch connection is much smaller. Turning the key to 'start' provides a low current voltage to the solenoid causing the solenoid relay to close and power from the battery cable to connect through to the starter. If that voltage is present then the solenoid or the wiring between the solenoid and battery or solenoid and starter is suspect. If that voltage is missing then the starter switch or solenoid feed line may have failed.
The starter solenoid is located on the starter. It would be more cost-effective to have the entire starter replaced with a good remanufactured unit on this application.
The wire from the battery to solenoid is corroded & should be replaced.
If the starter will not engage on a 1994 Geo Tracker, it is possible that the solenoid needs to be replaced. There could also be a loose wire on the starter solenoid. Also check that the battery is fully charged. The battery could have gone dead while it was being driven.