answersLogoWhite

0

Take a look under the hood at the top of the engine on the right side of the intake manufold. There is a vacuum line that connects to a rubber boot. that boot pops off at times or may be torn. Replace the rubber connector and everything should be fine...

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What causes a hard rattling knocking sound under the hood when you start your 98 ford windstar?

What causes a hard rattling knocking sound under the hood when you start your 98 ford windstar? Lack of oil, lack of oil pressure, badly worn camshaft or crankshaft or a combination of all the above.


Why is your Ford Expedition hard to start?

why does my ford expedition crank over but not start all the time


How hard is it to change blown head gaskets on a 1996 Ford Windstar 3.8L V6 engine?

It is a big job. If you attempt it, get a manual from AUTOBOOKSONLINE.COM


What repair is needed when the key is hard to turn on a Ford Windstar GL?

Try putting lubricant on the key or in the ignition or both. It worked for mine.


Cold Weather Hard start Mazda?

My 1999 Mazda 626 is hard to start any time but then we kick start it then it start fine and dies at any robot will I'm driving My 1999 Mazda 626 is hard to start any time but then we kick start it then it start fine and dies at any robot will I'm driving


Does a 1999 Ford Contour have struts in rear?

Yes they do have struts and they aren't hard to change


Coolings system knocking then knocking stops and no heat ford windstar 1999?

I can say with the highest confidence your temperature blend door actuator motor has failed. It is the #1 cause of heating problems on the Windstar line. Luckily it's not too hard of a fix, and not too expensive ($45). See "Related Questions" below for more details and lots of good tricks & tips on replacing the actuator.


Where is the speed sensor located at on the transmission ford windstar 98?

on the top of the transmission it is very hard to get to i just got mine changed at a shop and i watched the guy change it.


How will your 2001 Ford Windstar act if the catalytic converter is bad?

Hard starting, loss of power, poor fuel economy, and a blowing noise under full acceleration.


1999 Pontiac sunfire why is it hard to start after it is warm?

when it is worm you got to keep the throttle down to start


Why does a 1999 Ford ranger hard to start and then backfire?

A 1999 Ford Ranger may be hard to start and backfire due to several potential issues, such as a faulty ignition system, fuel delivery problems, or a malfunctioning sensor. Common culprits include a failing fuel pump, clogged fuel filter, or worn spark plugs and ignition coils. Additionally, a vacuum leak or issues with the engine timing can also contribute to these symptoms. It's advisable to perform a diagnostic check to pinpoint the exact cause.


What would cause a 1996 ford explorer stalls and hard to start not always but most of the time?

There are several things that can cause your 1996 Ford Explorer to stall in start hard. The most common cause is a fuel pump that is going bad.