turn on the running lights and pull out on the multi switch.
well, i had this problem wasnt on a wrangler, but it was on a 92 Cherokee sport. anyways... after pulling my hair out for hours it was a simple...IT was the rear defrost fuse. Why that one?... i dunno, but i caused an electrical problem w/ my starter
If a washer pump was replaced on a Jeep Wrangler and is still not working the fuses should be checked. The washer switch should also be checked as it could also be causing the pump not to work.
If the engine stops running when the key is released, then the ignition switch is probably bad. The switch will need to be replaced.
No. A Jeep Wrangler does not have an inertia switch.
The 1994 Jeep Wrangler that will not start and is having the auto shutdown relay clicking, is having a problem with the auto shutdown relay switch. The switch needs to be replaced because this is what is stopping the vehicle from starting.
Try pulling the headlight knob towards you (carefully, don't force it if it doesn't go, but a lot of Chrysler products use this type of switch now).
A 2002 Jeep Wrangler does not have a reset switch.
what is the switch located in the battery tray on a 98 jeep wrangler
If you mean the headlight switch, pulling it out once turns on the dash lights and turns off the daytime running lights, pulling it again turns on the headlights.
I have the same problem with my 1998 wrangler, I have been told it is the Multi-function switch in the steering column, but I have not changed it yet, can't seem to find it at local auto parts store!
headlamp switch