answersLogoWhite

0

It could just be that the timing is to high on the engine. so you need to check the electronic timing control module, on the left side of the engine by the valve cover mounted on a bracket. It could be keeping the timing advance. I have seen this happen a lot. Need to check battery too. If the starter is old,it could very well be draging, and needs replaced.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Would cold weather cause any starter related problems on a 1998 Chevy Z71 pickup with 350cid V8 engine?

When a engine is real cold, The oil in it becomes thick and heavy, The intire engine contracks and everything inside of it gets tighter then it would be if is was warm. So in terms; The starter has to be in good working condition to be able to turn the engine over. There's alot of starter problems in the winter time.


What would cause a 350 Chevy to start when cold but starter drags and will not start when warm?

BAD STARTER OR TIMING OFF LEAKING FLOATS


1991 Chevy pickup wont start when engine is warm has new starter Rocking the truck pushing it or hitting the starter with a hammer will sometimes make it click or just waiting will help?

you have an oil leak which is leaking down into your starter causing it to not operate. fix your oil leak clean out the oil from the starter, put the starter back on and everything will be everything


Why will the starter drag after the engine is warm when trying to start but no problem when cold?

When the engine is warm, the oil becomes less viscous, which can lead to increased friction in the starter motor or related components, making it work harder to turn the engine over. Additionally, heat can cause components like the battery or ignition system to perform less effectively, reducing the available power to the starter. If there are any issues with the starter itself, such as worn brushes or a failing solenoid, these problems may become more pronounced when the engine is warm, leading to drag.


You just put a Chevy 350 in your truck it will crank fine when cold but grinds at warm up?

could be bad bushings in the starter.


Car starter does not work when engine is warm?

Solenoid is getting hot from heat transfer. Wire in a remote solenoid.


The engine temp on my 1997 Chevy cavalier is 195 after warm up is this normal?

Yes it is normal. That is the temperature that the engine was designed to operate.


At what RPMs should your Chevy silverado 4.3 L engine idle at?

It should be idling at approximately 625 rpm while the engine is warm.


How do you set timing if starter is dragging?

If the starter is dragging because of a timing issue, the timing is over-advanced. This becomes more obvious when the engine is warm. If it is dragging so bad you can't even start it, retard the timing a little bit and try to start it. If retarding the timing improves the problem, it verifies that it was indeed over-advanced timing. Once you get it running, use a timing light to set the timing to original specs. If original specs are unknown, 8 degrees BTDC was a VERY common setting for the 350, and will most likely work just fine. Don't forget to disconnect the vacuum advance hose if your distributor has one when you set the timing with a light.


1990 olds toronado wont start when its warm up?

the starter may be worn on your car if it starts up easily when its cold but slowly turns over when it is at the operating temperature. Replace the starter to your engine.


How to check transmission fluid in 74 Chevy truck?

If you have an automatic transmission, check with the engine warm and running, The dip stick is located on the passenger side rear of the engine.


1993 Ford Ranger 3.0L when you turn ignition there is a click and about a second delay then the engine starts it only does this when cold not warm already replaced starter solenoid so what now?

resistance somewhere in starter circuit