answersLogoWhite

0

U little pig

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How to remove torque converter bolts off a 2000 izusu trooper?

There is a small access panel underneath that you must remove first in order to access the torque converter bolts. The panel is very small so a socket and wrench should be used. Bolts should be 17MM. Good luck!


Does a torque converter come with a used transmission?

That depends on the seller of the transmission.


Does a manual transmission have a torque converter?

No, a manual transmission uses a clutch. Torque converters are used on automatic transmissions.


What is the Need for converter system used in power system?

to control a speed and torque.


How do youget hosepower of of a small block Chevy engine?

A dynomometer. This is a device used to measure HP, and torque, amongst other things, with the motor in, or out of the car.


What does a tcc solenoid do?

the TCC,, torque converter clutch,,,, used on tree speed transmission in the 80's GM and on 4 speed automatics, the solenoid reads the speed of the transmission (car) and sends the signal to the computer which identifies that the car has reached proper crusing speed and is not under heavey load (full throttle) it then "locK" the torque converter to not allow any slippage like a standard automatic torque converter, basically making the torque converter act like a clutch,,, thus the name TCC torque converter clutch hope that helps,,


What is used to transfer energy through torque converter components?

ATF (Automatic Transmission Fluid)


How Does Torque Converter Works on Tractor Head?

It does not connect to the head. The torque converter connects directly to the crankshaft of the engine. IA torque converter is a modified form of fluid coupling that is used to transfer rotating power from an internal combustion engine or electric motor, to a rotating driven load. Like a basic fluid coupling, the torque converter normally takes the place of a mechanical clutch. In a torque converter there are at least three rotating elements: the pump, which is mechanically driven by the engine; the turbine, which drives the load; and the stator, which is interposed between the pump and turbine so that it can alter oil flow returning from the turbine to the pump.


Why cant the torque converter bolts line up on a 1995 gmc 3500 with a 350 engine after switching with the same engine?

If the torque converter bolts on a 1995 GMC 3500 with a 350 engine aren't lining up after an engine swap, it could be due to misalignment of the torque converter or the flexplate. Ensure that the torque converter is fully seated in the transmission and that the flexplate is properly aligned. Additionally, check if the correct torque converter and flexplate combination is being used, as variations in part design may also affect alignment. Lastly, inspect for any obstructions or damaged components that may prevent proper installation.


What is the mechanism used to minimize torque in tricopter?

A small tilt is applied to one rotor to counteract yaw from unbalanced rotor torque


What is 4 inch drill pipe torque up to?

A 4 inch drill pipe torque is used for fishing in small casing.


How can you increase torque in transmission?

There is few ways of increasing torque inside the transmission. The most obvious one is using a torque converter of which is used to transfer rotating power from a prime mover such as the combustion chamber. Also, you can replace your rear end gears with taller gears.

Trending Questions
What size windshield wiper blades go on a 2004 Chrysler Sebring coupe? What is the fuel tank capacity of a 2004 530I BMW? You need to recharge your ac on a Lincoln ls 2000 v8 where is the low side connection? Where is the relay switch for the seat warmers for the driver and passenger side seats in a 2000 Mazda Millenia? What are some common problems with a Chevy beretta? Your 1992 Buick Century has a DTC 26 code how can you find out what this is? When I start my 1992 Cadillac Deville the engine runs at high. When I turn my car off the gas pedal pumps itself for a couple of minutes and there is a clicking in the engine. Please help? Is there a 5 speed transmission for a 1980 Chevrolet 4wd? Can a 1991 ford Crown Victoria transmission fit in a 1988 ford Crown Victoria? How do you replace the brake pads and rotors for a 1999 Oldsmobile Aurora? What is the firing order of a 98 ford ranger? What is the fuel tank capacity for a 2000 Ford Ranger? Brake and turn signal lights don't work for a 1998 Chevy suburban how can this be fixed? Should you change all the glow plugs at the same time if one goes out on a 2000 Ford F 350 powerstroke V8? Where is the oil cap on a 1985 GMC sierra? What would cause the lights to dim and the belt to squeal on a 98 jeep Cherokee and the volt meter to drop? What size are the stock speakers on a 1993 Chevy c1500? How do you replace the odometer bulb on a 1999 Buick Regal? How do you change front brake pads on a 2004 Chevy Trailblazer LS 4WD? Which fuse controls the rear wiper on a 2003 4 runner?