0
The bolt size for a Turbo 350 torque converter is typically 11mm or 7/16-inch, depending on the specific application and manufacturer. Most commonly, the bolts used are Grade 8 bolts, which provide the necessary strength for securing the torque converter to the flexplate. Always refer to the vehicle's service manual for precise specifications and torque settings.
What else can I help you with?
What size bolt on a 700 R 4 transmission commonly used to bolt torque converter to flex plate?
Usually 3/8, but it's ok to step up to 7/16.
How much transmission fluid goes into the torque converter after replacing transmission in a 1999 buick century?
what transmission is in it?? turbo 350??? My 82 firebird has roughly the same size torque converter and should hold around 4 liters. make sure you flip the torque converter on its side after you put some in so it drains into the sides of the converter, put another liter in and do the same. if you have any other questions email me at aka_sparxxx@hotmail.com
What size are the starter bolts on a 1994 GMC 6.5 turbo diesel?
What size is the starter bolt on 6.5 turbo diesel starter?
What size torque converter to get for a Chevy 350?
Consult the converter manufacturer of your choice for a recommendation based on your application.
What size bolt needed to bolt 350 turbo to a 350?
3/8-16x1 1/4
What are the torque specs for a Chevy 350- 4 bolt main engine?
which bolts are you talking about? every different size bolt has a different torque spec.
Connecting rod torque Chevy 350?
The rod torque on a Chevy 350 V8 depends on which size rod bolt you have. On the 3/8 rod bolt the torque is 45 ft/lbs On the 11/32 rod bolt the torque is 35 ft/lbs
What is the torque setting for a 24mm 8.8 bolt?
If you mean a bolt with a head size of 24mm (M16) then the recommended torque setting will be 210Nm but if you mean a head size of 36mm (M24) then the recommended setting will be 710Nm.
What is the rear caliper bolt torque on a 2005 Honda Odyssey?
caliper bolt size 2007 Honda odysey
What is the torque spec for front center bolt?
97 buick lesabre center front wheel bolt size
The right torque for a Chevy intake with aluminum heads?
I believe the torque is figured on the bolt size, not the material. you are using steel bolts ,therefore the torque for an intake bolt on a sm. block is 20 ft. lbs.
90 degrees of torque how many ft-lbs is this .?
It is not really answerable, depends on many factors. Bolt size thread pitch of the bolt material the bolt is made of that material the bolt is screwed into lubricated/unlubricated and what with what it was initially torqued to If you have Snap on tech100/250 torque wrench it will give you a final torque #, I have seen torque readings double the intial torque # after the 90 degrees.
