No , all it does it ground out to cause spark just like a spark plug
no gas or fuel pump not working.
Yes. It only goes out when the proper coded key is inserted in the ignition.
ignition switch
If the 2003 Focus is running good then suddenly shakes and looses power, check the fuel system for proper pressure. If the pressure is correct, check the ignition system for fire, the ignition components could be starting to fail.
You need to dry out the ignition circuit to no 3.
The brake fluid reservor is located at the back of the engine compartment near the firewall. The reservoir has a black cap with wires running into it - take off the cap and lift out the attached float mechanism - then pour in brake fluid up to the proper level.
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
Do NOT use Diesel fuel in a Ford Focus. The engine will stop running and you will have to drain the gas tank to rid the car of the diesel fuel. Gasoline engines are not designed to run on diesel. They do not have enough compression to cause the diesel fuel to combust The only engine used in a 2000 Ford Focus was the 2.0 which is NOT a diesel engine.
Hi, The focus does not really have an ignition coil. It has a coil pack ( spark plugs ) but I think what you want is the coils in the starter. There are two coils the primary and secondary both are located in the starter itself. the coil back just trace back the wires. pretty sure it is on the left front of you engine.
Yes ( the 2.0 liter four cylinder gasoline engine used in North America does ) on a 2009 Ford Focus . The four spark plugs are under the four individual ignition coils
A little picture of an "engine" to the left of the speedometer. Turn on the ignition without starting the car and the light should appear. If it does not, the bulb is burnt out or has been removed.
To reset the oil life indicator on a Ford Focus after an oil change, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within five seconds. Then, turn off the ignition and start the engine to ensure the oil life indicator has been reset. If done correctly, the indicator should display 100%.