0
Yes, the thermostat in a 2000 Oldsmobile Bravada can be cleaned and reused if it is functioning properly and not damaged. To clean it, you can remove the thermostat, soak it in a solution of vinegar or a specialized cleaner, and scrub off any deposits. However, if the thermostat shows signs of wear or does not open and close correctly, it's best to replace it to ensure optimal engine performance.
What else can I help you with?
How do you replace the thermostat on a 2000 Oldsmobile bravada?
To replace the thermostat on a 2000 Oldsmobile Bravada, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove the upper radiator hose connected to the thermostat housing. Unscrew the thermostat housing, replace the old thermostat with a new one (ensuring the rubber gasket is in place), reassemble the housing, reconnect the hose, and refill the coolant before reconnecting the battery. Finally, start the engine and check for leaks.
How much to replace front axles on 2000 bravada?
how much to replace axles on a 2000 bravada
Where is the thermostat in a 2000 bravada?
On the front, top of the motor (Closest to you. It has a radiator hose attached to it and is a pipe shaped like a "J". It also has 2 bolts holding it to the motor.
Heated seats in a 2000 bravada?
What about them?
Where is the fuel tank pressure sensor on a Oldsmobile Bravada 2000?
The Fuel Tank Pressure Sensor on a Oldsmobile Bravada 2000 is on the top of the Fuel Pump Assembly.
Is the 2000 Olds Bravada e-85 compatible?
No
How much horsepower does the 2000 bravada have?
190 h.P.
What type of refrigerant on a 2000 Oldsmobile Bravada?
r134a
Where is the thermostat on 2000 Mercury Mystique?
where is the thermostat at on a 2000 mercury mystique
What type of oil do you use in a 2000 Oldsmobile bravada?
5w30
What transmission fluid do you use on Oldsmobile 2000 Bravada?
The 2000 Olds Bravada uses Dextron iv automatic transmission fluid. The fluid is specific and other types should not be substituted.
How do you change a Thermostat on a 2000 chev blazer?
ON THE TOP OF THE INTAKE IS A STEAL WATER NECK THAT THE TOP RADITOR HOSE IS ATACHED THE TWO BOLTS THAT HOLD IT DOWN NEED TO BE REMOVED THE SURFASE CLEANED AND THE WATER NECK CLEANED REPLACE THERMOSTAT AND O-RING I PUT A THIN LAYER OF SILICONE TO HELP WITH POS. LEAKS DUE TO CORISON .
