0
What else can I help you with?
How do you set speed limit to cruise control of ford probe lx 1989?
I have a 1989 Probe LX. 1. make sure the button on the cruise control is IN 2. press the button on the end of the stalk at desired speed. 3. setting can then be changed up/down by raising or lowering the stalk. 4. the 'speed alarm' function has nothing to do with the cruise control.
Will a 1989 ford probe transmission out of the 4cly fit the 1990 probe v6 both being a 5 speed?
i think that it might work
How do you locate and replace the speed sensor in a 1989 ford probe lx with a digital dash?
To locate and replace the speed sensor in a 1989 Ford Probe LX with a digital dash, first, ensure the vehicle is safely lifted and secured. The speed sensor is typically located on the transmission, near the output shaft. Disconnect the electrical connector and remove the retaining bolt to take out the old sensor. Install the new sensor, reattach the connector, and ensure everything is secured before lowering the vehicle.
How do you disable an alarm that is continuously beeping on a 1989 Probe that seems to be coming from the vicinity of the Speed Alarm or Keyboard area above the stereo?
Theres a plug under the drivers seat/the drivers seat is pluged into/if this is connected the chimes will drive you crazyalso the headlight has a chime on some cars to tell you the lights are on with the key turned off
When was Ford Probe created?
Ford Probe was created in 1989.
How do you disable the alarm on a 1989 BMW 735il?
To disable the alarm on a 1989 BMW 735iL, locate the alarm control unit, which is typically found under the dashboard or in the trunk. Disconnect the battery to reset the system, or locate the alarm's fuse in the fuse box and remove it. If the alarm has a key fob or a manual override switch, using those could also disable the alarm. Always refer to the vehicle's owner manual for specific instructions related to your model.
How do you check your transmission fluid on a 1989 Ford Probe?
how to check the fluid on a manual transmission for a 1989 ford probe gt
Can a turbo from a 1989 Ford Probe be used on a 1989 Ford Probe non turbo?
if you have the exhaust manifold, oil lines, etc. from the 89 GT then yes.
What was the first year the Ford Probe was introduced?
The first model year of the Ford Probe ( in North America ) was ( 1989 )
How do you set ignition timing on a 1989 ford probe?
where are timing marks on 89 ford probe 4 cylinder I have the bottom not the top
How much does a 1989 Ford Probe gt weigh?
about 2900 pounds
What type of freon refrigerant does a 1989 Ford Probe use?
r12
