answersLogoWhite

0

the only other way that i know of is to lift the box. I just bought a 93 ranger that the previous owner cut an access pannel in the floor of the bed. made it easy to put the new fuel filler neck in but now i have this nasty hole in the bed of my new (OLD and BEAT UP) truck.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove a fuel tank on a Nissan Titan?

Easiest way is to remove the bed. Then you can remove it without dropping the tank.


How do you remove a fuel tank on a 2004 Nissan Titan?

Easiest way is to remove the bed. Then you can remove it without dropping the tank.


How can you change the transmission fluid in F100 without dropping the pan?

You could remove the transmission and pour it out of the rear driveshaft seal. But I would recommend dropping the pan.


How do you repair fuel filler hose on 1997 Ford ranger?

you don't you replace the whole hose. i hear it is better to remove the bed, than to remove the gas tank. You can drop the tank, but that is too hard, better lift the bed and do it the easy way. As soon as you begin to lift the bed you have to remove the three screws holding the filler neck to the bed, open the filler door you will see the three screws. Lift the bed and replace the filler neck. also if any other hose is bad you can do those at the same time.


How do you get fuel out of the fuel tank on a 1988 Ford Ranger?

Remove the filler neck assembly then wiggle a siphon hose down into the tank. Be careful not to allow dirt and crud get into the tank.


How do you siphon gas from a 1997 Chrysler town and country?

You can not. There is an anti siphon valve in the filler neck. You have to remove the filler neck from the tank and drain from there.You can not. There is an anti siphon valve in the filler neck. You have to remove the filler neck from the tank and drain from there.


How can I effectively remove a stain over wood filler?

To effectively remove a stain over wood filler, you can lightly sand the area to remove the stained layer, then reapply wood filler and restain the surface for a seamless finish.


How do you replace the fuel filler hose on a Ford Ranger?

The gas tank must be removed. First disconnect the fuel neck from behind the fuel door. Next remove all of the bolts for the heat shield, remove heat shield. Disconnect the gear clamp from the back side of the filler neck. Now you will need to release the tank straps via two bolts prevously covered by the heat shield. Lower the gas tank using a floor jack. The pump wires and hoses are long enough for the tank to set on the ground without disconnecting them. Now the filler hose is accessable remove the gear clamp and pull it of of the tank.


Can you replace the tank fuel pump on a 1988 ranger without having to take bed off truck and just dropping the tank itself?

You must either raise one side of the bed enough to get the fuel pump out of the top of the tank or remove the fuel tank.... NO OTHER WAY.


How do you remove a 1996 2L megane coupe gearbox via the bottom of the engine?

can't be done without dropping subframe


How do you remove the C5 front license filler?

2 small screws under the filler


How do you replace a fuel pump in a 1996 k1500 suburban?

You must remove the fuel tank as it is located on top and inside the tank, unless you can remove it without dropping the tank.