answersLogoWhite

0

No expert but it sounds like it could be a fuel restriction while under power. Perhaps it's time for a new fuel filter.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

1988 corvette idles rough after changing rotor cap plugs and wires. No idiot lights?

recheck wires to plugs sounds like two are crossed


Can anyone help 97 GMC starts then quits when it does run it only idles cuts out when accelerating new fuel pump new plugs new wires new rotor new cap?

Have you changed the fuel filter?


Why does the engine shake when it idles?

Might be time for a tune up, new plugs, fuel filter, pcv valve, cap and rotor and wires if aplicable.


Why is your 95 Toyota Camry feel like misfiring after you changed the plugs cable plugs and rotor .?

It is feeling silly and my other answer is it is behaving badly


Changed the spark wires spark plugs and distributor cap now car will crank but not start?

Check/replace Rotor Check for spark at plugs


How do you tune up a Chevy Tahoe?

Plugs, wires, rotor, distributor cap, air filter, oil and filter, check radiator level, tire pressure. That is about it.


Changed rotor cap plugs wires coil on 1990 caprice still no spark what could be the problem?

try the moduel


What is changed when doing a tune up up on 2001 durango?

Plugs, wires, cap, rotor, air filter, pcv valve.


96 Chevy Tahoe gets fuel but no spark?

there are many reasons, but the easiest to eliminate would be plugs,wires, cap, rotor and coil. after those it could even be a computer problem.


Have a 97 cavalier 2.2litre engine has misfire from idle to half throttle what could be doing this changed plugs and wires?

could be distributor cap or rotor


Why is my aerostar misfiring when warm even after I have changed plugs and wires and also fuel and air filters?

check cap and rotor..... check valve clearance "cold"


How do you tune up 1999 Chevy Astro?

When I tuned up my 99. I changed, plugs, wires, distributor cap, rotor and ignition coil. To my knowledge that is about all you can do. I would by the cap and rotor from the dealer. I made the mistake of not doing that and had problems with the aftermarket cap and rotor getting corroded.