answersLogoWhite

0

under dist cap, oassanger side of car

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where is the fuel level sensor on a 1999 gmc sonoma?

Inside the fuel tank


Where location of a camshaft sensor GMC Sonoma 95 4.3 V6 Vortec?

The sensor is down on the front of the oil pan just behind the crankshaft pully, which is located at the front of the engine.


Where is the crankshaft position sensor on 1994 GMC Sonoma 4.3 vin w?

Pretty sure it's at the front end of the crank.


Where is the crankshaft sensor for a 1995 gmc jimmy?

The crankshaft sensor is by the crankshaft pullie (the balancer)


Where is the IAT senor in a 2003 gmc sonoma?

where is the iat sensor located on a 2003 gmc sonoma truck


Where is the crank position sensor located on a 1997 gmc sonoma 2.2?

were is csp on gmc sonoma 2.2


Where is the crankshaft sensor on a 2002 GMC Sonoma?

On a 1998 it is about 3/4 of the way down the drivers side of the motor (4 cyl.) Middle of the block.


Where is crankshaft sensor on 2000 gmc sonoma 2.2?

The crankshaft position sensor on a 2000 GMC Sonoma with a 2.2L engine is located on the engine block, near the flywheel. Specifically, it is typically positioned on the driver's side, towards the rear of the engine, just above the transmission bellhousing. To access it, you may need to remove some components or cover panels to reach the sensor. Always consult a repair manual for detailed instructions specific to your vehicle.


Where is the crankshaft position sensor located on a 1996 Gmc sonoma?

Bottom of the timing case on battery side..... look for the lowest wire connector in this area ...... best to get at from underneath.


Where is the map sensor located on the GMC Sonoma?

The MAP Sensor on the GMC Sonoma is located in the engine compartment just to the left of the alternator. The MAP Sensor is usually colored silver or shows a gold tint.


How do you change fuel vapor sensor on a 1997 gmc sonoma?

To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.


Is there an emergency cutoff switch on a 99 Sonoma and where is it?

there is no cut off switch on a 1999 gmc sonoma