Bottom of the timing case on battery side..... look for the lowest wire connector in this area ...... best to get at from underneath.
The crankshaft position sensor on a 97 GM Sonoma 2.2 engine is located on the lower right side of the engine. It is near the ignition control module.
were is csp on gmc sonoma 2.2
Pretty sure it's at the front end of the crank.
The sensor is down on the front of the oil pan just behind the crankshaft pully, which is located at the front of the engine.
The crankshaft sensor is located on the passenger side of the engine, close to the coil pack. It is easier to reach it from under a raised vehicle.
The crankshaft position sensor on a 2000 GMC Sonoma with a 2.2L engine is located on the engine block, near the flywheel. Specifically, it is typically positioned on the driver's side, towards the rear of the engine, just above the transmission bellhousing. To access it, you may need to remove some components or cover panels to reach the sensor. Always consult a repair manual for detailed instructions specific to your vehicle.
under dist cap, oassanger side of car
The MAP Sensor on the GMC Sonoma is located in the engine compartment just to the left of the alternator. The MAP Sensor is usually colored silver or shows a gold tint.
where is the iat sensor located on a 2003 gmc sonoma truck
Check the Sonoma crank position first. If the sensor is bad then there will be no spark from the coil.
The camshaft sensor is located inside the distributor.
On a 1998 it is about 3/4 of the way down the drivers side of the motor (4 cyl.) Middle of the block.