0
What else can I help you with?
How do you replace Fuel pump on a 1992 caprice classic and does it have an access plate?
No access plate, You must remove the gas tank, When you remove the sending unit the pump will be on the bottom of it. Just remove the old unit and install the new one in the same way. BE CAREFUL NOT TO ALLOW DIRT TO ENTER THE TANK. I would advise to replace the pump, filter, ansd pickup sock.
What is the cost to replace clutch on 1991 Nissan pickup?
Takes about 19 hours all up to replace clutch plate pressure plate and thrust raceproviding you have access to a hoist.
How do you change the license plate light on a 1984 Chevy caprice classic?
take the 2 Phillips head screws out and pop the cap off put the new bulb in ur good to go
How do you replace the fuel pump on a 1991 Caprice Classic?
The fuel pump is located in the gas tank. Drop the tank and disconnect the fuel lines from the fuel pump top plate. Use a screwdriver (or other flat blade) and a hammer to knock the retaining ring around. Lift the entire assembly out and the fuel pump will be attached to the assembly. Remember that when you replace the pump, you should also replace the screen (sometimes called a sock).
How replace an oil filter in VW Touareg V8?
You must remove the skid plate to access the oil filter.
What is the name of the panel around the radio on a 1984 caprice?
face plate
1978 caprice fuel filter located?
behind the rear plate
Do you need a front license plate in Idaho?
Yes you do but there are some exemptions for classic cars. If you qualify for a special classic plate then you can only run 1 plate.
How do you change spark plugs on a 1997 Mercedes C200?
Disconnect the battery, remove the air hose to the throttle body, remove the access plate, remove the spark plug cables and the boots, and remove the spark plugs. Replace the spark plugs, replace the boots and cables, replace the access plate, attach the air hose to the throttle body and connect the battery.
What has to br done to replace a 99 gp flex plate?
The transmission has to be dropped first. then the torque convert/clutch needs to be removed to gain access to the flex plate, which can then be replaced.
How do you replace fuel level sending unit 1994 Chrysler LHS 3.5?
there is an access plate in the trunk. Remove carpet remove and replace. Beware of gas fumes and spillage.
How do you put gas in your caprice 1985 it ran out a week a go?
BEHIND THE LICENSE PLATE
