0
What else can I help you with?
What is the torque specs on intake manifold bolts for dodge durango 5.9?
75 lbs
Where is the map sensor on a 2002 Dodge Intrepid?
The Map Sensor mounts to the drivers side of the intake manifold plenum.
Location of injectors on a 2000 Dodge Intrepid?
They're under the upper intake manifold next to the cylinder heads.
Where is your torque conversion sensor on 1997 Dodge Intrepid?
where is torque conversion sensor on my 1997 didge intrepid?
Where is the coolant temperature sensor located in a 94 Dodge Intrepid?
on the intake manifold, close to the thermostat housing, which is at the end of the top radiator hose on the engine.
Where do you find the intake manifold on 94 Dodge Intrepid?
The intake would be the large aluminum housing that U'll first view after raising the hood.It sits directly on the top-middle of the engine.
Where is the intake air sensor on a 2002 Dodge Intrepid?
On a 2002 Dodge Intrepid, the intake air sensor, commonly referred to as the intake air temperature (IAT) sensor, is typically located in the intake manifold or air intake duct. It is often positioned near the air filter or throttle body, where it can accurately measure the temperature of the incoming air. To locate it, look for a small sensor with an electrical connector attached to it along the air intake path.
Where is the thermostat located on a 1997 Dodge Intrepid Sport?
Find the top radiator hose and follow it back to the thermostat housing, which should be located towards the fron of the engine on the intake manifold.
Can you put a Dodge 5.2 intake manifold on a 3.9 Dodge engine?
No.
Should there be tranny fluid in the torque converter on a 2001 Dodge Intrepid?
yes
What are the torque specifications for a 1996 Dodge Intrepid main barring cap bolts?
The 1996 Dodge Intrepid main bearing torque specification is 180 pounds. The main bearings should be torqued in 60 pound intervals.
How do you remove the intake manifold on a Dodge Magnum?
To remove the intake manifold on a Dodge Magnum, first, disconnect the battery and remove any components obstructing access, such as the air intake and throttle body. Next, detach the fuel lines and vacuum hoses, and unbolt the manifold from the engine block. Carefully lift the manifold off, ensuring that any gaskets or seals are removed with it. Be sure to follow a service manual for specific torque specifications and procedures for reinstallation.
