push in turn to the left and pull out
You have a burned out bulb on the right side. Even a the side marker bulb will affect the turn signal
If its a Olds Cutlass Supreme, its a fairly easy process. Grab the turn signal stalk firmly near its base. Gently wiggle, and slightly twist while pulling it out. Replace with the new stank and plug in the small plug at the base of the stalk. And your done If you are talking about a Olds Cutlass Ciera, its not a easy process, and I pay to get it done.
nevermind
I also want to know that...
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
The headlight assembly on a 95 Olds Cutlass Ciera is removed by disconnecting the wiring harness and removing the bulb. The assembly can then be unbolted and removed from the vehicle.
what is a 1998 olds moblie cutlass value
2 clips at the front... slide a flat screwdriver into them and pry off the lens carefully. when it gets undone, pull the lens forward out of the rear clips. when it comes loose, the bulb will be in it attached to a power line. twist and pull the bulb from the lens and replace it with the right type.
where is the emc located on a 1988 olds cutlass?
Usually up under the dash on the right side of the ashtray.
bulb
how do you drain s 1999 olds cutlass radiatoe