remove the crews from the seat and then tilt the seat to the back u dont have to take the seatbelt screw out remove the screws holding the door handle and then get a screwdriver (flat) bend the tip 2" and use it to take the panel out open the panel and remove the cover that is tape to the door locate a bar that will have a cover (white) hold and move to the left the door will open take the handle out and check it!
The linkage is connected by plastic bushings and with age they deterioate.
To replace the linkage on the driver's side windshield wiper of a 2001 Ford Explorer XL, first, lift the wiper arm away from the windshield and remove the nut securing the wiper to the linkage using a socket wrench. Next, detach the wiper arm and remove the plastic cover from the base of the wiper assembly to access the linkage. Disconnect the linkage from the motor and the other components, then install the new linkage by reversing the process: connect it to the motor, secure it, and reattach the wiper arm and cover. Finally, test the wipers to ensure proper operation.
On a 2000 Ford Explorer, the Vehicle Identification Number (VIN) is typically located in several places. The most common locations are on the driver's side dashboard, visible through the windshield, and on the driver's side door jamb, where the door latches when closed. You may also find it on the vehicle's title and registration documents.
yes it will
Get under the driver side of the suburban by the driver door and their should be a linkage that you can loosen
It is the part that connects the handle the driver moves with the linkage on/inside the transmission.
It is on driver side of Transmission behind the shift linkage
The driver.
underneath the Explorer , on the driver's side , mounted in the frame rail , I believe somewhere below the driver's door (Helpfull)
Underneath the Explorer , on the driver's side , mounted in the frame rail somewhere below the driver's door is where you will find the fuel filter (Helpfull)
If the passenger side works but the driver side doesn't, the linkage under the arm is broken.
On the driver's side of the F 150 carb, there should be the linkage for the throttle. On the linkage there should be a set screw that you can turn to adjust the engine idle.