To adjust the headlights on a Dodge Neon, park the car on a level surface about 25 feet from a wall or garage door. Turn on the headlights and mark the center of the light beam on the wall with tape. Use a screwdriver to adjust the vertical and horizontal screws located on the headlight assembly until the top of the beam aligns with the tape mark. Always check the alignment after adjustments to ensure proper visibility.
2005 Dodge neon has a rear adjustment for TOE only
from the factory the rear of a neon has limited adjustment available for alignment, with aftermarket parts more adjustment is available
It is not a cover, the headlight is a sealed assembly.
9007
9007
it is behind the passenger side headlight assembly. you will have to remove the headlight assembly to replace it.
if you can get a copy of the Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036 it can help with the answer.
Never.
I just replaced my headlight on my 2003 sx.2. There is only one adjustment and that is up and down. At the back of the assembly you will see a hole in which a screwdriver can be placed to turn an adjusting rod.
Under the passenger side headlight assembly, you have to remove the entire assembly to get to it.
No it won't. The SRT-4, along with other 2003-2005 Dodge Neons have a different headlight mount assembly than 2000-2002 Dodge Neons. If it was 2003-2005 it would fit.
Open the hood of the engine compartment. Remove the wiring harness from the headlight. Remove the retaining bolts from the headlight assembly. The headlight unit will come out. Reverse the process to install the new headlight.