0
securely and safely jack up rear of van supporting both sides. A vehicle falling can Kill pay particular attention to how you support vehicle, make sure it's on a level surface, won't roll etc. If you can't safely support the rear axle assembly off the ground, hire a professional.
pull cover, drain gear oil, find holding bolt on pin, 5/16 head, remove, remove pin. push axle in and c-clip will fall out. don't push vehicle off jack stands or supports, falling vehicles can maim or kill. Remove axle, now you see bearing, check axle for damage from bearing, replace worn parts as necessary. Don't forget, lifting a vehicle off the ground can be dangerous, if you can't do it safely hire a professional.
what is the hose going into gear housing. do i disconnect. how or why.
What else can I help you with?
Where are the springs on a Chevy Astro van 1995?
Behind the wheels, attached to the axle.
How do you find the gear ratio on the rear axle of a 1999 Chevy Astro?
should be a plate mounted on one of the bolts on the chunk that will tell you the chunk is the big thing in the middle of the axle
How do you change 5 lugs to 6 lugs on Chevy trucks?
You have to change axle and hubs
How do you change the front axle on 2001 Chevy Impala?
take it to a shop
How do you change front axle on Chevy aveo?
To change the front axle on a Chevy Aveo, first, raise the vehicle and secure it on jack stands. Remove the wheel and brake components, then disconnect the axle from the hub by taking out the axle nut. After that, detach the axle from the transmission by removing any retaining bolts or clips, and pull the axle out of the hub and transmission. Install the new axle by reversing these steps, ensuring all bolts are properly torqued.
How do you replace the front wheel bearings on a 97 awd Chevy astro van?
Remove the tire and wheel from your 1997 Chevy Astro. Remove the axle end. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new front wheel bearing.
How do you change wheelbearing in a 2002 Chevy Venture?
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
What size is the axle nut on a 2003 Chevy cobalt?
what size is the axle nut on a 03 chevy cobalt
Need to see how to replace seal and baring and snap rings on a 1996 izuzu trooper front axle?
Show video on
Where is the oxygen sensor on 1995 Chevy Astro Van?
I have a 1997 Astro and there are actually three (3) oxygen sensors on it. One on each down tube of the Y before the catalytic converter and one between the catalytic converter and the muffler back toward the rear axle. The one the driver's side Y isn't bad to change. The one on the passenger side is impossible and the one to the rear is tough as well.
How do you change a rear end axle seal on a 1969 Chevy Nova?
To change the rear end axle seal on a 1969 Chevy Nova, first, lift the vehicle and secure it on jack stands. Remove the wheel and brake drum, then unbolt the axle retaining plate to access the axle shaft. Carefully pull out the axle shaft, replace the old seal with a new one by tapping it into place with a seal driver, and reassemble by reversing the steps. Ensure everything is torqued to specification and check for leaks after refilling the differential fluid.
How do you remove baring and rotor fromfromt axle from f 150 2002 ford 8.6 xlt?
please tell me how to remove the bering and rotor?how do i get the answer?
