Yes
You have to change axle and hubs
take it to a shop
To change the front axle on a Chevy Aveo, first, raise the vehicle and secure it on jack stands. Remove the wheel and brake components, then disconnect the axle from the hub by taking out the axle nut. After that, detach the axle from the transmission by removing any retaining bolts or clips, and pull the axle out of the hub and transmission. Install the new axle by reversing these steps, ensuring all bolts are properly torqued.
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
The axle ratio on a 1969 Ford Mustang axle was 2.75:1
what size is the axle nut on a 03 chevy cobalt
To install traction bars on a 1969 Chevy Nova, first lift the rear of the car and secure it on jack stands. Remove the rear shocks and any existing components that may obstruct installation. Position the traction bars according to the manufacturer’s instructions, typically attaching them to the rear axle and the chassis. Finally, tighten all bolts to the recommended torque specifications and re-install the shocks.
you have to pull the axle completely out of the rearend and the bearing is on the axle and you have to press it off the axle to get it off and press the new one on.
You must remove the axle to replace the backing plates. It is job for the professional do-it-yourselfers with all the tools.
Please clarify your question as in front or rear axle.
Front axle nut should be a 35mm.