The regulator is the part that raises the window. Can be a notched curved piece and a X shaped arm that raises the window or a plastic strip that runs in a grove. The motor can be changed. I belive regulator and the motor are both held in by rivots. These can be drilled out and replaced with bolts.
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
You can find sliders for a window regulator on an Oldsmobile Alero at most auto parts stores. Another option, is to check with local junk yards.
how do I replace the passenger side window regulator on an E250, 2006. the window will not release to push to top of window frame only half way?
Window regulator controls the up and down motions of your car window. Both electric and manual windows have a window regulator. Not the easiest part to replace, but once you dissembled the door panel it should be fairly simple to replace.
replace the window regulator.
To replace a rear window regulator on 2005 CTS Cadillac remove the side protection panel of the car door then adjust the regulator.
To replace a 2001 Ford Focus window regulator, first, remove the door panel by unscrewing and unclipping it to access the regulator. Disconnect the window from the regulator, then unbolt the old regulator from the door. Install the new regulator in reverse order, reconnect the window, and reassemble the door panel. Finally, test the window operation before securing everything in place.
It is easy to replace the window regulator or window clips on the rear window of a 2000 Grand Am. The clips simply snap right onto the rails inside that door that connect to the window.
No
How to remove the window motor from the regulator
Replace defective window regulator
To replace the passenger rear window regulator in a 2001 Oldsmobile Aurora, first, disconnect the negative battery terminal to ensure safety. Remove the door panel by unscrewing any screws and gently prying it off to access the regulator. Disconnect the electrical connector and remove any bolts securing the regulator, then carefully replace it with the new one, reconnect the electrical connector, and reassemble the door panel. Finally, reconnect the battery and test the window to ensure proper operation.