0
Remove the tire and wheel from your 1999 Chevy Lumina. Remove the nut on the top of the ball joint. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.
What else can I help you with?
How do i change both lower ball joints on a Chevy lumina?
take old ones out... put new ones in
How do you replace the front wheel hub on a 1999 Lumina?
The front wheel hub on a 1999 Chevy Lumina is connected to several suspension components. Loosen and remove all the components including the lower and upper ball joints. Pull off the hub assembly and install the replacement.
How do you change lower ball joints on a 1994 lumina?
Drive it to the local garage and pay to have it done.
How do you drain your radiator for a 99 Chevy Lumina?
i just disconnected the lower hose
Where can you get a picture of where lower raditor hose goes on 1995 Chevy lumina?
You can get that picture from google.com.
1999 Chevy S10 front end squakes?
Typically the squeaks in the front end mean you need to replace the ball joints. I recommend doing both upper and lower ball joints at the same time.
Where is the starter in a 1994 Chevy Lumina?
6 cyl.? Look at the lower rear end of the engine.
How do you replace the front lower ball joints on a 1995 Intrepid ES 33L V6 automatic?
You can't service the lower ball joints by themselves. You must replace the entire lower control arm.
Cost of replacing an intake manifold on 1999 Chevy lumina?
upper or lower? if it's lower you can bet on paying upwards of 400$
How do you replace ball joints on 1995 Nissan truck?
how to replace lower ball joints on 1995 4 wheel drive Nissan truck
Are the ball joints on the lower control arms on a 2000 ford explorer xls 4x2 replaceable or do you need to replace the whole lower control arm?
You can replace just the ball joints on the lower control arms , but the upper ball joints come with a new control arm
How do you replace the upper and lower ball joints on a 2002 Chevy S10 pickup truck?
If its 2 wheel drive, you will need a press. Those ball joints are pressed into the upper and lower control arms. If it is 4 Wheel drive you need to remove the rivets with either an air chisel or to drill them out.
