Many auto parts stores will do this for you. If you would rather, just disconnect the negative battery cable, wait for five minutes, and reconnect it. That will reset nearly everything. My question is "Why did the light come on in the first place?" Ignoring the light could, at the least, cost you at the gas pump, and at the worst, leave you with more costly repairs in the future.
What model do you have? I am saying no to your question. In most vehicles the service engine light deals with the operation of the "engine", igniton system, exhaust, and fuel system. If there is a problem with the brakes you could see an ABS light (if equiped) or a BRAKE! light on. If the Service engine soon light is on in your vehicle the problem lies in one of those systems. Good Luck
To reset the service light on a Kubota tractor, first turn the ignition key to the "on" position without starting the engine. Next, press and hold the "Hour Meter" button or the "Service" button, depending on the model, until the service light blinks and then turns off. Release the button, and the service light should be reset. Always consult your owner's manual for model-specific instructions.
Service engine lights need to be read with a code reader for your make and model. If the problem has already been fixed, you can reset the light by removing the appropriate fuse, or disconnecting the negative battery terminal for at least 30 seconds.
disconnect the negative battery cable, wait a couple hours, then reconnect. If you are trying to reset the inspection service light you will need to take it to someone or get on a board for model specific info.
To reset the service performance light on a 2007 Jeep Commander, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds, then turn the ignition off. Restart the engine, and the service light should be reset. If the light remains on, it may indicate an ongoing issue that needs to be addressed.
To reset the service light on a Mazda 3, first, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within five seconds. Then, turn off the ignition and start the engine to check if the service light has been reset. If the light remains on, you may need to repeat the process or consult your owner's manual for specific instructions related to your model year.
To turn off the service light on a Renault Clio, first ensure that the vehicle is in the "ON" position without starting the engine. Then, press the trip reset button on the dashboard until you see the service interval display. Finally, hold the button for about 10 seconds until the service light resets. If the light remains on, consult the owner's manual for specific model instructions.
I am not sure about the 2007 model. 2004-200 Models: The answer is in the manual. If you do not have the manual: After you turn on the engine, hold the trip reset button until the service remainder resets.
Bad plugs Wires, Distributor cap, Points if older model This is just a few things
How do reset the oil service light on a 2001 polo?
To reset the service light in a Subaru Forester, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within 10 seconds. Afterward, turn the ignition off and then start the engine to check if the service light has been reset. If it remains on, you may need to repeat the process or consult your owner's manual for specific instructions based on your model year.
It was used with my 96 Mercury Villager V-6 engine. I believe, though, it was a Nissan engine, also used in the Nissan Quest. - dt