Most of these now require changing the entire arm when replacing the upper ball joints. Any national parts chain will carry them.
need to replace the wheel gear box on a 2002 ford excursio.
yes i can
If its 2 wheel drive, you will need a press. Those ball joints are pressed into the upper and lower control arms. If it is 4 Wheel drive you need to remove the rivets with either an air chisel or to drill them out.
Raise the car up and check out the lower ball joints. You can grab the upper arm and if it rocks you need to replace the lower ball joints. Also look at the outer tie rods and suspension components
Part Of Upper Control Arm
I think 2000-2002 are welded in.
According to the 2002 Excursion Owner's Guide, it should be a 20A fuse in fuse location #18.
According to the 2002 Ford Excursion Owner Guide : ( 166.6 litres / 44.0 U.S. gallons )
To replace the thermostat on a 2002 Cavalier 22 Ecotec, drain the radiator and remove the upper hose assembly. Replace the thermostat and refill the radiator.
To replace the horn on a 2002 Ford Excursion, first, disconnect the battery to ensure safety. Next, locate the horn, which is usually found behind the front grille or near the radiator. Remove the mounting bolts and disconnect the wiring harness from the old horn. Install the new horn by connecting the wiring harness, securing it with bolts, and then reconnect the battery to test the horn.
more than likely 400$. just do it yourself.
Worst Best Friends - 2002 The Excursion 1-1 is rated/received certificates of: Australia:G