open the end gate remove the hold down screws and carefullt remove the taillight assembly
how do you change tail light cover on a 1994 ford ranger
The 2001 Ford Ranger pickup truck tail light fuse can be found in the fuse box. The tail light fuse will be in the first column, fourth from the bottom.
check brake light switch
To replace the tail light lens on a Ford 500, first, open the trunk and locate the access panel behind the tail light assembly. Remove the screws or clips holding the tail light in place, then gently pull the assembly out. Disconnect the wiring harness, remove the lens by unscrewing it, and replace it with the new lens. Reassemble everything by reconnecting the wiring, securing the tail light, and closing the access panel.
slot 13
To hook up a Leer cap brake light to a 2005 Ford Ranger, first, locate the wiring harness for the tail lights in the truck. Use a wire stripper to access the brake light wire, typically the green wire with a yellow stripe. Connect the brake light from the Leer cap to this wire using a secure connector or soldering, ensuring a solid electrical connection. Finally, test the brake light to confirm it operates correctly before securing all connections.
install 99 tail lights and there is no issue.. head over to www.ranger-forums.com for more answers
The brake light fuse might keep tripping or going out on a 2001 Ford Ranger is there is a short in the line. The fault could also be with the part that tells the brake light to come on. This is located in the steering column. There is a brake light relay switch where the brake pedal is attached to the steering column.
if turn signals are working , and brake lights not working, i would replace the stop light switch on the brake pedal
Yes, these tail lights are interchangeable.
Open tailgate. Remove the light assembly screws. Rotate the bulb socket to align the lugs and take the socket out of the housing. Carefully pry out the ratainig clip and pull the bulb out of the socket. Installation is the reverse. - Haynes Manual #36071, 1993 - 2005 Ford Ranger Pickups, all models.
twist and pull pig tail, you need to pull the pig tail out of the fixture from behind the bumper, then install a new #57 bulb and push and turn the pigtail back into the fixture.