To change the O2 sensor on a 1997 Geo Prism, first, locate the sensor, which is typically found in the exhaust manifold or exhaust pipe. Disconnect the negative battery cable, then unplug the electrical connector from the sensor. Use an O2 sensor socket or a wrench to unscrew the old sensor, and then install the new one by threading it in and tightening it securely. Finally, reconnect the electrical connector and the negative battery cable.
Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.
it is right under the motor. it will be black with a bolt sticking out on the botom of it.
Most auto parts stores have information on capacities on their computers. I know O'Reilly's does. Just give them a call.
Yes the Geo Prism has ait bags.
remove the battery
it can be done but you will have to change all of ur wirring harness from the prism because the prism is basically a Toyota and a storm is a izuzu impulse knockoff
The intake air temperature sensor on a Geo Prism would be a part of the air intake system. More specifically, it would be on the engine side of the air cleaner housing.
Trouble code P0141 means:O2 sensor heater circuit malfunction (Bank 1 Sensor 2)
How do you replace power steering pressure hose on a 1993 geo prizm
The Geo Prism is a compact car that was produced by General Motors under the Geo brand from 1989 to 1997. It is essentially a rebadged version of the Chevrolet Prizm, which was developed in partnership with Toyota. The Geo Prism typically features front-wheel drive and is known for its fuel efficiency and reliability. It was available with a range of four-cylinder engines during its production run.
It is possible as the signal from the oxygen sensor is sent to the computer
It should be no more than 15mins.