answersLogoWhite

0

* Remove rear wheel * Remove brake drum

* Pry off grease cap * Remove cotter pin, adjusting nut & flat washer * Wiggle the hub to push the outer bearing out * Lift the hub off * pry off the oil seal to remove the backside bearings Re-installing note: Tighten the nut to 18-23 ft. lbs. while rotating the hub to set the end-play. Back off the nut and retighten it to 18 inch lbs

See "Related Questions" below for more about removing the drum when it doesn't want to come off.

User Avatar

Wiki User

15y ago

What else can I help you with?