I did this last week on my 99 avenger. What you want to do is remove the air intake and the battery, they get in the way and make it hard to remove the covering. Next remove 4 bolts from the place where the thermostat is. mine was directly on the right of the engine. Take out the screws and remove the old thermostat. Insert new one and put everything back where you got it.
195
Changing a thermostat on a 2008 Dodge Avenger can be difficult because there area two thermostats. One is located under the intake manifold inside a housing unit, and the second is at the end of the radiator hose.
If you follow the bottom hose on your radiator it will lead you to it. You will have to remove 3 bolts on the thermostat housing to get to it but it should only take you about 20 minutes to change it out.
If you follow the bottom hose on your radiator it will lead you to it. You will have to remove 3 bolts on the thermostat housing to get to it but it should only take you about 20 minutes to change it out.
How do I change a Wiper motor for a 99 dodge avenger?
replace it. when they go bad you can't fix them.
The dealership would be a good place to start.
hh
under the housing where the lower radiator hose hooks to the engine
Dodge Avenger was created in 1995.
To install a thermostat on a 2008 Dodge Avenger with a 2.7L engine, start by disconnecting the negative battery terminal. Drain the coolant and remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, replace the old thermostat with the new one, ensuring the new gasket is in place, and then reassemble everything in reverse order. Finally, refill the coolant, reconnect the battery, and check for leaks.
The average time it takes to change the water pump on a 1998 Dodge Avenger is six to ten hours.