To change the multifunction switch on a 2007 Dodge Caliber, first disconnect the negative battery terminal to ensure safety. Remove the steering column covers by unscrewing the screws, then disconnect any necessary wiring. Next, unbolt the multifunction switch from its position, carefully detach it from the steering column, and replace it with the new switch. Reassemble everything by reversing the steps, reconnect the battery, and test the new switch for proper operation.
The turn signal switch is part of the multifunction switch.The turn signal switch is part of the multifunction switch.
The turn signal switch is part of the multifunction switch.The turn signal switch is part of the multifunction switch.
yes
The oil pressure sensor on a Dodge Caliber is under the intake manifold on the front of the engine.
Turn signals, wipers, high/low beam
The multifunction switch mount screw should be a T20 torx.
Dodge does not use inertia/reset switches.
no
Remove the tilt steering lever.Remove the steering column cover.Unplug the wire going to the switch.Now you can remove the bolts that hold the switch to the column.An instructional video of how to remove the multifunction switch on a 1993-1997 Dodge Intrepid has been included below.
A wire is broken, or pulled out of the multifunction switch plug.
how do caravanu change ignition switch in 93 dodge
yes