The ECM is bolted to the firewall inside the car behind the glove box.
To change the ECM:
1. Remove the under dash panel making careful note of the location of screws so they can be replaced.
2. You can see what you are doing better if you pull the glove box out of the dash and put it aside.
3. Open the latches and remove the wiring harnesses.
4. Remove the bolts that hold it in place and pull it out.
Re-installation is the reverse.
Yes
It is the main computer box.
The engine control computer, ECM, is located on the inside of the firewall directly behind the glove box.
The 1989 Chevrolet Celebrity uses distributorless ignition. The spark is controled by the ECM, engine control module, and cannot be re set, or go out of time.
No you can not , That is what makes and keeps the engine running
The 1988 Chevrolet Celebrity uses idistributorless ignition systems, the timing is controlled by the ECM. there is no provision for adjustment.
The computer, ECM, is on the firewall inside the car and behind the glove box.
The ECM will be programmed to shut it down around 105 mph.
The ECM, computer, is bolted to the firewall inside the car behind the glove box. To Change the ECM: 1. Remove the under dash panel. 2. Remove the glove box for better visibility. It makes it easier to see what you are doing, but is not completely necessary. 3. Un-latch the wire loom plugs and pull them out. 4. Remove the bolts and pull the ECM out. Reverse the above to put the ECM back in.
depends on engine, mounting, body, ecm, and about a million other things, but possibily
The ecm does with input from various sensors.
Where is the ecm located in a 2000 Chevy Malibu