Remove the 3 coils which are help on by 2 5.5 mm bolts each. The module is now free. Remove electrical connector from ignition module. - Tech JK -----------------------------------
To change the ignition on a 1997 Oldsmobile LSS, start by disconnecting the negative battery terminal to ensure safety. Remove the steering column covers to access the ignition switch, then disconnect the wiring harness from the ignition. Use a screwdriver to remove any screws securing the ignition switch, and replace it with the new one. Reassemble the steering column, reconnect the battery, and test the ignition to ensure it's functioning properly.
1997 lss stalls may start after hours or days
Does the LSS have a 3.8L engine? If so, the crank sensor is behind the crank pulley/harmonic damper.
Mine has 195,000 miles and still counting......
About 22 liters in my 1996 Oldsmobile LSS
Have you heater core replaced.
To change the front brakes on a 1996 Oldsmobile LSS, you'll need a few tools: a jack and jack stands, a lug wrench, a socket set, and a C-clamp or brake tool for retracting the caliper piston. Start by safely lifting the vehicle and removing the front wheels. Then, unbolt the caliper, replace the brake pads, and compress the caliper piston before reassembling everything. Finally, ensure all components are securely fastened and bleed the brakes if necessary.
do you go to LSS
The acronym LSS stands for Logistics Support System.
The population of LSS Data Systems is 200.
LSS Data Systems was created in 1982.
6.5 seconds, on a bad day....with a nice cold air intake and high flow exhaust.. 5.8