I NEED PICTURES IF POSSIBLE TO TAKE DASH APART
how do you check a/c codes on a 2000 Cadillac Seville sls
To change the radiator hose on a 1995 Cadillac Seville SLS, first ensure the engine is cool and disconnect the negative battery terminal. Drain the coolant from the radiator, then loosen the hose clamps on both ends of the old hose and remove it. Install the new hose by securing it to the radiator and engine, tightening the clamps, and refill the coolant before reconnecting the battery. Finally, start the engine and check for leaks.
To change the oil pan gasket on a 2001 Cadillac Seville, first, ensure the vehicle is safely lifted and supported. Drain the engine oil and remove the oil pan by unbolting it from the engine block, taking care to note the positioning of any components. Clean the surfaces of the oil pan and engine block, then place a new gasket in position and reattach the oil pan with new bolts as necessary. Finally, refill the engine with oil and check for leaks after starting the engine.
If the speedometer stopped working on a 1990 Cadillac Seville, it could be the fuse or an electrical problem. First check the fuse and if the fuse is good, check with a mechanic.
On a 1999 Cadillac Seville STS, the oil dipstick is located on the passenger side of the engine, near the rear. It is typically a yellow or orange loop for easy identification. To check the oil level, simply pull the dipstick out, clean it with a cloth, reinsert it, and then remove it again to check the oil level.
Check: Autotrader.com Kbb.com Hemmings Motor news
Yea my cadillac light check engine whay
To reset the check engine light on a 1995 Cadillac Seville, you can disconnect the negative battery terminal for about 15 minutes, then reconnect it. This will clear the onboard computer's memory and turn off the light. Alternatively, you can use an OBD-I scanner to clear the codes if you have access to one. However, ensure any underlying issues are resolved to prevent the light from coming back on.
To reset the change oil light on a 1996 Cadillac Seville, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, the oil change light should reset and turn off. If it remains on, you may need to repeat the process or check for any underlying issues.
The coolant capacity of a 2000 Cadillac Seville is approximately 12.0 quarts (or about 11.4 liters) when including the engine and radiator. It's important to check your owner's manual for the most accurate specifications and to ensure proper maintenance. Always use the recommended coolant type for optimal performance.
The 2003 Cadillac Seville SLS typically has two engine belts: the serpentine belt and the accessory drive belt. The serpentine belt drives multiple accessories, including the alternator, power steering pump, and air conditioning compressor. It's important to check the vehicle's manual for specific details, as configurations can vary slightly depending on the engine type.
If the running lights won't go off on a 1997 Cadillac Seville, it could indicate a problem with the wiring. Check to ensure all wires are intact.