To reset the check engine light on a 1995 Cadillac Seville, you can disconnect the negative battery terminal for about 15 minutes, then reconnect it. This will clear the onboard computer's memory and turn off the light. Alternatively, you can use an OBD-I scanner to clear the codes if you have access to one. However, ensure any underlying issues are resolved to prevent the light from coming back on.
I NEED PICTURES IF POSSIBLE TO TAKE DASH APART
Yea my cadillac light check engine whay
To reset the check engine light on a 2001 Cadillac Seville SLS without a computer or disconnecting the battery, turn the ignition key to the "On" position without starting the engine. Then, press the gas pedal to the floor three times within five seconds. This method may clear the light, but if the underlying issue isn't resolved, the light may return. Always ensure to address any underlying issues that triggered the light.
It means the engine computer has detected a malfunction and set a trouble code.
The check engine light on a 1999 Cadillac DeVille can be reset by disconnecting the battery for 30 seconds. The light will immediately come back on if the problem still exists.
Hi, I have a 2002 Cadillac Seville SLS. I would like to know how to reset the stability system? my message light came on.
Check engine is on BECAUSE the speedo is inop, assuming it was not on prior to speedo malfunction. Speedo is electronic. Could be numerous reasons ( no fuses are involved). Could be something simple like an electrical disconnect at transmission. Good luck
I have a 2001 Seville Cadillac that the service Engine soon light comes on after I happen to use certain fuels. It seems that ethanol type fuels are the worst. The light will go out after I put in a higher octane fuel. Not sure this is my complete problem but it always seems to go out in time. I keep wondering if there is some type of fuel additive I could add that would make the light go out faster.
Reading the codes requires a scan tool.
because your oxygen senser's need replaced after you do that your light will go off and you will also get better mpg about 5 to 10 differant
You have to reset it with a OBC scanner :-)
To reset the change oil light on a 1996 Cadillac Seville, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, the oil change light should reset and turn off. If it remains on, you may need to repeat the process or check for any underlying issues.