answersLogoWhite

0

To change the speedometer drive oil seal on a Ford Transit gearbox, first, ensure the vehicle is securely lifted and supported. Remove the speedometer cable from the gearbox, then use a suitable tool to extract the old oil seal from its housing. Clean the area, apply a bit of oil to the new seal, and carefully press it into place. Reattach the speedometer cable and check for leaks after refilling the gearbox with oil if necessary.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Toyota Cressida speedo drive in gearbox out of position is this possible?

Yes, it is possible for the speedometer drive in the gearbox of a Toyota Cressida to be out of position. This misalignment can occur due to improper installation, wear and tear, or damage to the gearbox. If the speedometer is not functioning correctly, it may be necessary to inspect and realign or replace the speedometer drive gear to ensure accurate speed readings. Always consult a professional mechanic if you're unsure about the issue.


Your speedometer does not work on your frontera what could it be?

Most probable cause is the drive cable between gearbox and speedo has broken.


Your speedometer does not work on your fiat brava any advice?

Check that the drive cable ends haven't rounded or the small drive unit where it plugs into the gearbox has not stripped, some are plastic.


How do you change speedometer in a 1964 Nova?

Drive it and you can see it change before your very eyes!


Can you change your shaft drive on your motorcycle to a belt drive?

You will need to change the gearbox, swing arm, back wheel and, probably, brake arrangement and shocks.


Position of speedometer sender drive on fiat punto?

On the gearbox to the right hand side when looking from the front. To the back of the gearbox. Unplug wire and use 10mm spanner to undo. There is an o-ring so you need to pull a bit hard to get it out.


How do you recalibrate a speedometer?

Speedometer calibration differs depending on the vehicle and age. Some cars are calibrated by a technician with a computer program. Others require a gear change to drive the speedometer at a different ratio.


How do you go about changing the oil seals where the drive shafts go into the gearbox on your peugeot 306?

To change the oil seals where the drive shafts enter the gearbox on a Peugeot 306, start by safely lifting and supporting the vehicle. Remove the drive shafts by first disconnecting them from the hubs and then pulling them out of the gearbox. Use a seal puller to carefully remove the old oil seals from the gearbox, and then clean the area before installing new seals. Finally, reinsert the drive shafts, ensuring they are securely fastened, and check for leaks after refilling the gearbox with oil.


What do you need to change a 700R4 speedometer that is electric to a cable speedometer?

The early 700R4 transmissions had a cable drive speedo. Maybe you can swap the tail housing and gears over.


How long to change a gearbox in a astra g 1.7TD?

go to a garage, u ain't gonna get this done on your drive!


Where can you put a speedometer drive on a 1976 fxe other than the front wheel?

A speedometer drive can be installed in the transmission, and the speedometer cable will attach here. You may need a new speedometer as they used a variety of drive ratios. The speedo drive is a standard part for the fh, and is readily available.


The speedometer and tachometer is not working on my 1997 grand Jeep Cherokee what can you do?

You drive slow and change gears too soon.