answersLogoWhite

0

See Tail/Stop/Turn Signal and Sidemarker Lamps on page 6-38 of your "Owner's Manual", under Section 6: Service and Appearance Care - Bulb replacement...

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What does a change oil light mean in at 2004 Chevrolet impala?

Time to change your oil in your engine!


How do you change fog light bulbs 2000 Chevrolet impala?

There is one screw that holds the fog light it into place.Unscrew that screw and the fog light will pull out of the bumper.


How do you change the brake light switch on 1985 Chevrolet Impala?

It is mounted on a bracket under the dash at the brake pedal. From there it is self explanatory.


How to change bulb to tag light on 2002 impala?

How do you change a tag light on a 2002 impala


How do you remove hazard light switch 2000 impala?

http://www.topix.com/forum/autos/chevrolet-impala/T4P2NGT979PJ7QT2P


How do you change the horn on a 2001 Chevrolet impala?

take the pins of the front right light and look down and it will be there. size of the bolt is 10" mm PS. i put a horn of a Cadillac on my is sound good ( impala ls 05)


How do you change the light for the rear license plate on a 1999 Chevrolet Camaro?

Remove the cover using a tork bit.


How do you reset the change oil light on a 2000 Chevrolet Impala?

Turn the key to the run position and depress the accelerator pedal to the floor 3 times in 5 seconds. The light will blink and then go off.jd


How do you reset the low brake fluid warning light in a Chevrolet Impala?

Add brake fluid


How do you change the interior light bulbs on a Chevy Impala?

To change the interior light bulbs on a Chevy Impala, you will first need to locate the light fixture. This can usually be found on the ceiling of the vehicle's interior. Next, gently remove the plastic cover of the light fixture by using a flathead screwdriver or your fingers. Once the cover is off, you can then access the old bulb, twist it counterclockwise to remove it, and replace it with a new bulb of the same size and wattage. Finally, secure the plastic cover back in place and test the new bulb to ensure it is working properly.


How do you check for check engine light codes on 1984 Chevrolet Impala?

It requires a scanner to properly diagnosis a check engine light.


How do you change a tail light on 2003 impala?

dont