Chevy Camaro

How do you change the light for the rear license plate on a 1999 Chevrolet Camaro?

345

Top Answer
User Avatar
Wiki User
2008-09-08 01:51:54
2008-09-08 01:51:54

Remove the cover using a tork bit.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You will have to remove the lens either the front or rear. you did not say which.

User Avatar

usually a bad wheel sensor, get it checked out.

User Avatar

The orange wire is hot (positive) and the black is ground.

User Avatar

how do you change the light bulb over the license plate on 2000 eclipse

User Avatar

Remove two rear lamp bolt/screws from rear license lamp. Remove lacense lamp from rear bumper fascia. Remove license lamp bulb and socket from rear license lamp. Replace bulb and install using reverse procedure.

User Avatar

how do you change the rear license plate light on a 1999 Buick Regal

User Avatar

how to change the license plate bulb onLook at the rear plate , then get on the ground so you can look up to the underside of the bumper, where the plate is. There are two Phillips screws the hold your plate light, remove both, pull down gently on the light, then turn it co you can see the rear and with both Hans turn the socket and pull, there you will find the bulb. change it and do the reverse to install.

User Avatar

Remove the 2 bolts on either side of the lens which covers the bulb. Pull the bulb out of it's socket.

User Avatar

It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.

User Avatar

Hello, i my vehicle to camaro 1994 and in the board of instruments he/she did light to safe-deposit light and doesn't the car light that make for to unblock that light? Disconnect battery moment. Computer sometimes goes wacky on 94-97 Camaros. Faulty programming.

User Avatar

You will need to remove the 1998 Chevy Camaro brake light wiring harness. Remove the brake light retaining screws. Reverse the process to install the new brake light.

User Avatar

how do u change the license plate light on a 2005 sienna

User Avatar

It means that you have a low reading on one of the gauges and you need to address the problem.

User Avatar

Warning lights come on when there is an issue. A Oil change light with turn off when an oil change has taken place.

User Avatar

If your license plate light is out change the bulb in it, if you have taillights your fuse is good as the license plate light uses the same fuse as the taillights.

User Avatar

license plate light just pops out of the bumper with a screw driver.u can buy a new light at auto store or just change the light bulb

User Avatar

well there's almost 200 reasons of why take it to somewhere u can have the engine codes checked

User Avatar

If you have a pass key light "on" then in all probability it is a broken wire on the ignition lock cylinder.

User Avatar

it might be the chip in the key. i know it does it in later model cars.

User Avatar

It comes on when you need to change the oil.

User Avatar

The Chevrolet Colorado brake light switch is quite simple to change. The brake light switch simply plugs in and out.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.