0
To change the timing belt on a 1999 Chevy Metro 3-cylinder, first disconnect the battery and remove the serpentine belt. Then, remove the timing belt cover to access the timing belt. Align the timing marks on the crankshaft and camshaft, loosen the tensioner, and remove the old belt. Install the new timing belt by ensuring proper alignment, tighten the tensioner, reattach the timing cover, and reconnect the battery. Always consult a repair manual for specific torque specifications and detailed procedures.
What else can I help you with?
How do you set timing on 1998 3cylinder metro?
easy you buy a light and a book and follow the instructions!!.the book is only like 10 dollars at you local auto store
Where are Timing marks for 1.3 liter metro?
i need timeing marks for a 1999 1.3 chevy metro
Does a 2001 Chevy Metro have a timing chain or belt?
Chevy Metro 2001 (1.3 L) has a timing belt - hard driving conditions require its replacement at 60,000 miles, otherwise the timing belt replacement is scheduled for 100,000 miles.
Can you change an alternator belt from under a 1998 Chevy Metro?
can you change the alternator belt in a 1998 Chevy metro from under the car.
Where to buy 3 cylinder timing belt cover for a Geo Metro?
chevy
What year did the geo prism use a 3 cylinder engine?
The Geo Metro was the only Geo to have a 3cylinder engine.
How often do you need to change a timing belt on a 99 Chevy Metro?
every 100K miles, unless you drive it really hard ... if so, replace it sooner
Where are the timing marks for a 1.3L 4cylinder 1996 Chevy Metro?
The 1996 Chevy 1.3 liter engine timing marks can be found on the front main pulley and on the flywheel. The timing marks will be scattered around the outside of both locations.
How do you change the oil on a Chevy metro?
If I'm not mistaken you have to get underneath to change it. Should be a cap underneath it.
How do you set the timing on a 1999 Chevy Metro LSi?
timing does not need to be set on the 1.3l engine in model year 1999 as it is a distributor less igniton system all timing is done by the ecm
Where is the fuel filter located on a 2000 Chevy Metro?
IT DOES NOT HAVE ONElocation of Chevy metro fuel filterits located, so im told, on the top of the gas tank. the tank has to be dropped to change it.
Where is the timing check connector wire for a 1998 Chevy Metro?
on the front bottom part of oil pan. just behind the bottom pulley.
