2003 sunfire
1996 pontiac sunfire 2.2 crank was moved but cam was not could the timing get out 180 degrees before i put it back together
on the 2.4 its to the left of the starter above the oil filter
on the back of the motor wright below the crank sensor
Did John Brennen convert to Islam
it is located inside of the oil pan. if you have low pressure and have high milage you could have bad crank bearing.
it could have a bad air filter or the fuel is clogged some where. or the batt could be going bad.
On a 2005 Pontiac Sunfire, the crank position sensor is typically located near the bottom of the engine, mounted on the engine block or transmission bell housing. It's usually positioned near the crankshaft, often on the passenger side, making it accessible from underneath the vehicle. To replace or inspect it, you'll likely need to lift the car and remove any obstructions for better access.
remove the door panel and the window crank (if manual windows) , if auto windows remove the piece behind the door handle and unclip it from the buttons unscrew all screws around the door panel with a regular screw driver once you have done all that u will see the speaker remove it with a star head screw driver
Here is a site with that info, and for a lot of other vehicles: http://www.aera.org/downloads/Torque3.pdf
If an alarm system will not allow a vehicle to start the kill-switch is engaging. The brain of the alarm will need to be disarmed in order for the vehicle to start.
where is crank senser located on 2003 pontiac