Why would you want to disconnect it other than to keep your mileage down. That also works in conjunction with the ABS. If it is disconnected then it will show up in history codes.
It is not adjustable.
The throttle position sensor is located on the throttle plate.
usually a bad wheel sensor, get it checked out.
Yes
It is on the intake manifold near the thermostat housing.
It is on the intake manifold near the thermostat.
To remove the speed sensor on a 1999 Chevrolet S10, first, ensure the vehicle is parked on a level surface and the ignition is off. Locate the speed sensor, which is typically found on the transmission or transfer case. Disconnect the electrical connector by pressing the tab and pulling it off. Finally, use a socket or wrench to unscrew the sensor from its housing and remove it from the vehicle.
the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.
The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.
The O2 sensor bank 1 sensor 2 on a 1999 Chevrolet Silverado is located after the catalytic converter on the driver's side of the vehicle. This sensor monitors the oxygen levels in the exhaust gases after they have passed through the catalytic converter. To access it, you will typically need to crawl under the truck and look for the sensor mounted on the exhaust pipe. Be sure to disconnect the battery before working on the sensor to avoid any electrical issues.
same thing happened to my 95 camaro 3.4l it sounds like your coolant sensor
In a 1991 Chevrolet Camaro RS, the temperature sensor, also known as the coolant temperature sensor (CTS), is typically located near the thermostat housing on the engine. It is usually found on the intake manifold or engine block, depending on the engine type. To access it, you may need to remove any obstructions, such as air intake ducting or other components. Always refer to a service manual for specific details related to your vehicle.